PW logoaap PW WIEGAND Proximity Reader

aap PW WIEGAND Proximity Reader

Introduction

The PW Wiegand is a slim Wiegand Output keypad with proximity reader, compatible with 125KHz EM format card. The keypad is fully potted, and can function at extreme temperatures (-40℃ ~60℃), which allows it is capable to be mounted either indoor or outdoor.

Specifications

Operation Voltage9~24V DC
Standby Current≤50mA
Frequency125KHz
Card TypeEM card
Read RangeUp to 2.8 inches (7cm)
Output FormatAAP Custom 40-bit
Operating Temperature-40℃~60℃
Operating Humidity10% to 95% RH
ColorBlack
Index of ProtectionIP66
Dimension(H x W x T)103 x 48 x 20mm
Net Weight100g
Shipment Weight150g

Special Backlight Feature

The PW Wiegand device has the ability to automatically turn off its backlight after 20 seconds if no keys are pressed. To turn this feature Off press and hold the # key for 10 seconds. (the green led will flash to confirm) To turn this feature On press and hold the # key for 10 seconds. (the green LED will flash 4 times)

aap PW WIEGAND Proximity Reader 1

Wiring

ColorFunctionNotes
RedPower+DC (9-24V DC)
BlackGNDGround
GreenD0Data 0
WhiteD1Data 1
BlueLED1Red LED Light Control
BrownLED2Green LED Light Control
YellowBuzzerBuzzer Control

aap PW WIEGAND Proximity Reader 2

Function Table sheet

 

Read Card

The LED light will be turn into Green, and the buzzer sounds a beep, at the meantime, the reader outputs the Wiegand signal
External LED ControlWhen the input voltage for LED is low, the LED will turn into Green or Red
External Buzzer ControlWhen the input voltage for Buzzer is low, the Buzzer will sound
Wiegand Data OutputThis device has locked down software to allow it to com- municate with the Wiegand-IF2

ARROWHEAD ALARM PRODUCTS Ltd.

1A Emirali Road, Silverdale 0932, Auckland, NZ Ph. 09 414 0085 www.aap.co.nz

Documents / Resources

aap PW WIEGAND Proximity Reader [pdf] Instructions
PW WIEGAND Proximity Reader, WIEGAND Proximity Reader, Proximity Reader, Reader

References

Leave a comment

Your email address will not be published. Required fields are marked *