JBL logoGO 4
QUICK START GUIDE
BC

GO 4 Bluetooth Speaker

JBL GO 4 Bluetooth Speaker

WHAT’S IN THE BOX JBL GO 4 Bluetooth Speaker - icon

JBL GO 4 Bluetooth Speaker - In the box

BLUETOOTH PAIRING JBL GO 4 Bluetooth Speaker - icon 2

JBL GO 4 Bluetooth Speaker - BLUETOOTH PAIRING

PLAY JBL GO 4 Bluetooth Speaker - icon 3

JBL GO 4 Bluetooth Speaker - PLAY

MULTI-SPEAKER CONNECTION JBL GO 4 Bluetooth Speaker - icon 4

JBL GO 4 Bluetooth Speaker - CONNECTION

APP

Use the JBL PORTABLE app for speaker configuration and software upgrade.

https://storage.harman.com/release/portable/appqrcode/jblportableglobal.html
JBL GO 4 Bluetooth Speaker - APP

CHARGING

JBL GO 4 Bluetooth Speaker - CHARGINGJBL GO 4 Bluetooth Speaker - DUSTPROOF

TECH SPEC

Transducer: 45 mm /1.75″
Output power: 4.2 W RMS
Frequency response: 90 Hz – 20 kHz
Signal-to-noise ratio: > 85 dB
Battery type: Li-ion polymer 3.23 Wh (equivalent to 3.8 V / 850 mAh)
Battery charge time: 3 hours (5 V 1 A)
Music play time: up to 7 hours (dependent on volume level and audio content)
Bluetooth® version: 5.3
Bluetooth® profile: A2DP V1.4, AVRCP V1.6
Bluetooth® transmitter frequency range: 2400 MHz – 2483.5 MHz
Bluetooth® transmitter power: ≤ 9 dBm (EIRP)
Bluetooth® transmitter modulation: GFSK, π/4 DQPSK
Product dimensions (W x H x D): 94.3 x 75.7 x 42.2 mm / 3.7 x 3.0 x 1.7″
Net weight: 0.192 kg / 0.42 lbs
Packaging dimensions (W x H x D): 125 x 103 x 56.5 mm / 4.9 x 4.0 x 2.2″
Gross weight: 0.317 kg / 0.69 lbs
Maximum operation temperature: 45 °C

* Factory reset: To restore the factory settings, hold JBL GO 4 Bluetooth Speaker - icon 3 and + for more than 2 seconds.

Warning-icon.png To protect battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions.
Do not expose the JBL Go 4 to liquids without removing cable connection. Do not expose JBL Go 4 to water while charging. It may result in permanent damage to the speaker or power source. Chemicals, salt or “foreign particles” in your pool or the ocean can damage the waterproof seals or harm the connector surface over time if not rinsed off after use. After a liquid spill or rinse, do not charge your speaker until it’s completely dry and clean. Charging when wet might damage your speaker.
When using an external adapter, the output voltage/ current of the external adapter should not exceed 5V/3A.

JBL GO 4 Bluetooth Speaker - Symbol
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.
JBL GO 4 Bluetooth Speaker - Symbol 2

Documents / Resources

JBL GO 4 Bluetooth Speaker [pdf] User Guide
APIJBLGO4T, APIJBLGO4C, GO 4 Bluetooth Speaker, GO 4, Bluetooth Speaker, Speaker

References

Leave a comment

Your email address will not be published. Required fields are marked *