Cross Bars
Installation Instruction 
| NO. | ITEM | QTY |
| 1 | Front Crossbar | xl |
| 2 | Rear Crossbar | xl |
| 3 | Clamp | r4 |
| 4 | Screw | r8 |
| 5 | Wrench | x2 |
| 6 | Key | x2 |
| 7 | Instruction | xl |
INSTALLATION STEPS
- Remove the outer cover.
- lnstall the screws by the supplied wrench. Tighten each screw but allow the crossbar to be able to slide in the mount. The screw will be tightened once it is mounted on the car roof.
- Repeat the above step for each clamp.
- Using the provided wrench, loosen the bottom bolts on the four clamps.
NOTE: Do not fully remove the bolts. - Check the small yellow sticker on the crossbars, which indicating the front direction.
NOTE: The front crossbar is longer than the rear. (most vehicles)
- Mount the correct bar on the suitable location. Make sure the rubber piece is not pinched and is flat again the rail, which will protect the roof rail.
- Tighten the bottom bolts on the four clamps by the provided wrench, make sure the clamps are firmly attached to the roof rail.
- Once the clamps are securely in place and all of the bottom bolts are tight, tightened the small screws under the crossbars by the supplied wrench .
- Expose the keyhole by applying pressure to the key cover on the two lower corners. Insert the provided key from the groove side of the keyhole. Lock all the clamps and then fix the key cover into original place.
Please feel free to contact seller for any product
or installation problem.
Thank you for your support.
Documents / Resources
 | Snailfly C83 Cross Bars [pdf] Instruction Manual C83 Cross Bars, C83, Cross Bars |