Logotip HoneywellThor VM1A Vehicle Mounted Computer
Priročnik za uporabo 

Izven škatle

Poskrbite, da bo škatla za pošiljanje vsebovala te predmete:

  • Thor VM1A vehicle-mounted computer (Model VM1A-LON)
  • Regulatory Sheet If you ordered additional accessories for your computer, verify that they are also included with the order. Be sure to keep the original packaging in case you need to return the computer for service.

Lastnosti računalnika

 

Honeywell Thor VM1A Vehicle Mounted ComputerHoneywell Thor VM1A Vehicle Mounted Computer - Fig

Značilnosti priklopne enote

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 1

Standardna priklopna postaja

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 2

Enhanced Dock

 

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 3

Mount to Vehicle
The Thor VM1A should be secured to an area in the vehicle where it:

  • Does not obstruct the driver’s vision or safe vehicle operation.
  • Will be protected from rain or inclement weather.
  • Will be protected from extremely high concentrations of dust or wind-blown debris.
  •  Can be easily accessed by a user seated in the driver’s seat while the vehicle is not in operation. To mount the VM1A using a RAM mount system:
  1. Attach RAM base to a vehicle (RAM ball, RAM Clamp, RAM Plate, etc.)
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 4
  2. Attach RAM ball to the Smart Dock
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 5
  3. S pomočjo ročice RAM pritrdite sklop VM1A na osnovo RAM -a in zategnite gumb na roki RAM.

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 6

  • For more mounting details, refer to the user guide available at sps.honeywell.com.
    Connecting the Power Cable for 12-48 VDC Vehicles (10-60 VDC Direct Connection)
    Opomba: Refer to the Thor VM1A User Guide for other power connections, available at sps.honeywell.com.
    Pozor: Za namestitev samo usposobljeno servisno osebje.
    Warning: Fuse Requirements For proper and safe installation, the input power cable must be connected to a fused circuit on the vehicle. If the supply connection is made directly to the battery, the fuse should be installed in the positive lead within 5 inches of the battery’s positive (+) terminal. The fused circuit requires a maximum time delay (slow blow) fuse with a current rating as noted below.
  •  Za 12VDC vhod uporabite 10A varovalko s počasnim pregorevanjem z enosmernim tokomtage rating greater than 12VDC
  • Za 24VDC vhod uporabite 6A varovalko s počasnim pregorevanjem z enosmernim tokomtage rating greater than 24VDC.
  • Za 36VDC vhod uporabite 4A varovalko s počasnim pregorevanjem z enosmernim tokomtage rating greater than 36VDC
  • Za 48VDC vhod uporabite 3A varovalko s počasnim pregorevanjem z enosmernim tokomtage rating greater than 48VDC.
    Opomba: For North America, a UL Listed fuse must be used.

Usmerjanje napajalnih kablovHoneywell Thor VM1A Vehicle Mounted Computer - Fig 7

Shema ožičenja napajalnega kabla s pravim kotom in 6 žicami
Honeywell Thor VM1A Vehicle Mounted Computer - Fig 8Pred priklopom na napajanje vozila zvijte rdeče in rdeče/bele žice ter zvijte črno in črno/belo žico skupaj.
Connect the green wire to the vehicle ground:
Pozor: For battery-powered vehicles, the green wire must be connected to the vehicle chassis ground.
Pozor:  For internal combustion engine-powered vehicles, the green wire is connected to the vehicle chassis ground, which can also be battery negative.

Barva žice povezava
Rdeča DC + (10-60 VDC)
Rdeča / Bela DC + (10-60 VDC)
črna DC -
Black / White DC -
Zelen Igrišče
Modra Vhod za zaznavanje vžiga (neobvezno)
Refer to the Thor VM1A User Guide, available at sps.honeywell.comZa
further information about ignition control.

Neposredna povezava z električnim tokom 10-60 V DC

  1. The VM1A must not be mounted in the dock. The power switch on the dock must be turned Off. The power cable must be UNPLUGGED from the dock.
  2. While observing the Fuse Requirements, connect the power cable as close as possible to the actual battery terminals of the vehicle(if using unswitched power).
  3. Use proper electrical and mechanical fastening means for terminating the cable. Properly sized “crimp” type electrical terminals are an accepted method of termination. Select electrical connectors sized for use with 20AWG (0.81mm2) conductors.
  4. Za barve žic in povezave glejte naslednje sheme ožičenja:
    • Ignition Control Wiring Diagram If switched vehicle power is available, the ignition wire can be connected. The VM1A will boot up when the vehicle ignition is turned on. Honeywell Thor VM1A Vehicle Mounted Computer - Fig 9• Samodejno vklopljeno in ročno krmilno vezje Shema vžiga mora ostati odklopljena.
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 10Pozor: For battery-powered vehicles: Red and red/white wire twisted together to battery positive. Black and black/white wire twisted together to battery negative. The green wire connected to the vehicle chassis ground.
    Pozor: For internal combustion engine powered vehicles: Red and red/white wire twisted together to battery positive. Black and black/white wire twisted together to battery negative.  The green wire connected to the vehicle chassis ground can also be battery negative
  5. Route the cable the shortest way possible removing any leftover cable, and making sure the cable does not interfere with the safe operation and maintenance of the vehicle. The cable is rated for a maximum temperature of 221°F (105°C). The cable should be protected from surfaces that exceed this temperature, from physical damage from moving parts, and from chemicals or oil that cause the insulation to deteriorate. Avoid sharp bends. The power cable is less flexible in low-temperature environments
  6. Secure the cable to the vehicle structure at approximately one-foot intervals, taking care not to over-tighten, pinch conductors, or penetrate the insulation
  7. Connect the watertight connector end of the power cable to the dock power connector by aligning the connector pins to the power connector; push down on the watertight connector and twist it to fasten securely
  8. Secure the power cable to the VM1A using the strain relief cable clamps.
  9. Place VM1A in the dock
  10. If using the Screen Blanking feature, install the screen blanking box or switch. (Refer to the Thor VM1A User Guide, available at sps.honeywell.com, za dodatne informacije o polju za prazno zaslon.)
  11. Press the power switch on the back of the dock
  12. Press the power button on the front of the VM1A
  13. Konfigurirajte vedenje samodejnega vklopa.

Znova zaženite računalnik

Morda boste morali znova zagnati računalnik, da popravite pogoje, ko se aplikacija preneha odzivati ​​na sistem ali se zdi, da je računalnik zaklenjen.

  1. Pritisnite in držite gumb za vklop, dokler se ne prikaže meni z možnostmi.
  2. Izberite Znova zaženi.
    Če želite znova zagnati računalnik, če se zaslon na dotik ne odziva:
    • Pritisnite in držite gumb za vklop približno 8 sekund, dokler se računalnik ne zažene znova.

Opomba: Če želite izvedeti več o naprednih možnostih ponastavitve, glejte navodila za uporabo.

Podpora

Pojdi na sps.honeywell.com and select Support to search our knowledge base for a solution or to log into the Technical Support portal.
Uporabniška dokumentacija
Za navodila za uporabo in drugo dokumentacijo pojdite na sps.honeywell.com.
Omejena garancija
Za informacije o garanciji pojdite na sps.honeywell.com and select Support > Warranties.
Patenti
Za informacije o patentih glejte www.hsmpats.com.
Blagovne znamke
Android je blagovna znamka Google LLC.
Pogoji za uporabo
Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made. The information in this publication does not represent a commitment on the part of HII. HII shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. HII disclaims all responsibility for the selection and use of software and/or hardware to achieve intended results. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of HII. Copyright © 2021 Honeywell International Inc. All rights reserved

Dokumenti / Viri

Honeywell Thor- VM1A Vehicle-Mounted Computer [pdf] Uporabniški priročnik
Thor-VM1A Vehicle-Mounted Computer, Vehicle-Mounted Computer, Mounted Computer

Pustite komentar

Vaš e-naslov ne bo objavljen.