Brita Metro Water Filter Pitcher

Konec izdelkaview

The Brita Metro Water Filter Pitcher is designed to provide healthier, great-tasting tap water by reducing impurities. This BPA-free pitcher has a 6-cup capacity and features a SmartLight filter indicator to signal when filter replacement is needed. It helps reduce chlorine taste and odor, as well as copper, cadmium, and mercury impurities, contributing to a reduction in single-use plastic bottle waste.

Image: Brita Metro Water Filter Pitcher, showcasing its design and included filter.

Sestavine izdelka

Your Brita Metro Water Filter Pitcher consists of the following main components:

• Pitcher Base: The main transparent container for filtered water.
• Rezervoar filtra: The upper section that holds the filter and unfiltered water.
• Brita Standard Filter: The replaceable filter cartridge responsible for purification.
• Lid with SmartLight Indicator: The top cover featuring an electronic indicator for filter life and an easy-fill opening.

Image: Labeled diagram highlighting key features of the Brita pitcher.

Vodnik za namestitev

1. Prepare the Pitcher

Before first use, wash the pitcher base, filter reservoir, and lid with mild detergent and rinse thoroughly. Do not wash the filter with soap.

2. Prepare the Brita Standard Filter

Remove the filter from its packaging. Submerge the filter in cold water for 15 seconds to remove any air bubbles. This primes the filter for optimal performance.

Image: Cross-section diagram explaining the filtration process of the Brita filter.

3. Vstavite filter

Align the groove on the filter with the ridge in the filter reservoir. Insert the filter firmly into the reservoir until it clicks into place. Ensure a snug fit to prevent unfiltered water from bypassing the filter.

4. Assemble the Pitcher

Place the assembled filter reservoir into the pitcher base. Position the lid on top of the reservoir and press down firmly until it is securely seated.

5. Flush the Filter

Fill the reservoir with cold tap water. Allow the water to filter through completely. Discard the first three pitchers of filtered water, or use them for watering plants, as this helps to flush out any loose carbon particles and prepare the filter for drinking.

Navodila za uporabo

Filling the Pitcher

Open the easy-fill lid on the top of the pitcher. Place the pitcher under a cold water tap and fill the reservoir with water. The easy-fill lid is designed to allow direct filling without removing the entire lid.

Pouring Filtered Water

Once the water has filtered from the reservoir into the main pitcher base, it is ready for consumption. Simply tilt the pitcher to pour clean, great-tasting water.

Vzdrževanje

Zamenjava filtra

The SmartLight filter indicator on the lid will flash to remind you when it's time to change your filter. A green light indicates good filter life, yellow indicates it's time to order a new filter, and red indicates the filter needs to be replaced.

Standard filters should be replaced approximately every 2 months or after filtering 40 gallons of water. Elite filters, if used, last approximately 6 months or 120 gallons.

To replace, remove the lid and the filter reservoir. Pull out the old filter and dispose of it. Follow the "Prepare the Brita Standard Filter" and "Insert the Filter" steps from the Setup Guide for the new filter.

Image: The SmartLight indicator on the Brita pitcher lid.

Čiščenje vrča

Wash the pitcher base, filter reservoir, and lid regularly with mild detergent and rinse thoroughly. The pitcher components are not dishwasher safe and should be hand-washed.

Odpravljanje težav

Slow Filtration

If water filters slowly, ensure the filter is properly seated in the reservoir. Remove and reinsert the filter, ensuring a tight seal. If the issue persists, the filter may be clogged and require replacement.

Unusual Taste or Odor

If filtered water has an unusual taste or odor, ensure the filter was properly flushed during initial setup. Replace the filter if it has exceeded its recommended lifespan or if the taste/odor persists after flushing.

SmartLight Indicator Not Working

The SmartLight indicator is battery-operated. If it's not functioning, the battery may be depleted. Refer to the full user manual for instructions on resetting or troubleshooting the indicator.

Specifikacije

• Ime modela: Metro
• Številka modela: OB11/OB06
• Kapaciteta: 6 skodelice
• Dimenzije izdelka: 10.12 cm D x 10.04 cm Š x 4.82 cm V
• Teža artikla: 1.7 funta
• Vrsta filtra: Compatible with Brita Standard and Elite filters
• Material: Plastika brez BPA
• Posebna lastnost: SmartLight Filter Change Indicator (requires 1 Lithium Metal battery, included)
• Država izvora: Dominikanska republika

Garancija in podpora

For detailed warranty information and customer support, please refer to the official Brita website or the full user guide provided with your product. You can also find the user guide tukaj.

Za dodatno pomoč obiščite Brita Store na Amazonu.