Uniweld FL36 Flint Renewal Unit for FL35 Lighter Instruction Manual

1. Uvod

This manual provides essential instructions for the safe and effective use of the Uniweld FL36 Flint Renewal Unit. This unit is designed specifically as a replacement part for the Uniweld FL35 Lighter, ensuring reliable ignition for flame torches.

2. Izdelek je končanview

The Uniweld FL36 is a compact renewal unit containing three individual flints within a rotating cartridge. It is engineered to provide consistent sparks for igniting welding or brazing torches when used with the compatible Uniweld FL35 Lighter.

3. Navodila za namestitev

To replace the flint unit in your Uniweld FL35 Lighter, follow these steps:

1. Ensure the FL35 Lighter is cool and not in use.
2. Locate the existing flint unit on your FL35 Lighter. This is typically a small, triangular metal piece with flints.
3. Carefully remove the old flint unit. Depending on the FL35 model, this may involve unscrewing a small fastener or gently prying it out. Refer to your FL35 Lighter's specific instructions if unsure.
4. Insert the new Uniweld FL36 Flint Renewal Unit into the designated slot on the FL35 Lighter. Ensure it sits securely and the flints are positioned correctly to engage with the striker wheel.
5. If applicable, re-secure any fasteners removed in step 3.
6. Test the lighter by operating the striker mechanism to confirm a spark is produced.

4. Operating the Lighter with New Flint

Once the FL36 Flint Renewal Unit is installed, operate your Uniweld FL35 Lighter as usual:

1. Hold the lighter firmly.
2. Press the lever or squeeze the handles to rotate the striker wheel against a flint.
3. A spark should be generated, which can then be used to ignite a torch.
4. If no spark occurs, ensure the flint unit is correctly seated and the flints are not worn out. Rotate the cartridge to expose a fresh flint if necessary.

5. Vzdrževanje

The Uniweld FL36 Flint Renewal Unit requires minimal maintenance:

• Store unused units in a dry, cool place away from direct sunlight and moisture.
• Replace the unit when all three flints are worn down and no longer produce a reliable spark. The rotating cartridge allows you to utilize each flint before replacement is needed.

6. Odpravljanje težav

If your Uniweld FL35 Lighter does not produce a spark after installing the FL36 unit:

• Brez iskre:
  • Ensure the FL36 unit is correctly seated and fully engaged with the lighter's mechanism.
  • Check if the striker wheel is making proper contact with a flint.
  • Rotate the FL36 cartridge to expose a fresh flint.
  • If the issue persists, inspect the FL35 Lighter's striker wheel for damage or wear.

7. Specifikacije

8. Garancija in podpora

For information regarding warranty, technical support, or replacement parts, please contact Uniweld customer service directly. Refer to the official Uniweld webZa trenutne kontaktne podatke glejte spletno mesto ali embalažo izdelka.