SKYRC SK100055 E4 Balance LiPo Charger



SKYRC e4 Charger is an economic, high quality 100-240V AC balance charger, designed for charging LiPo and LiFe batteries from 2-4 cells in balance mode. The circuit power is 20W and max charge current can reach to 3A. There are three kinds of charge current 1A/2A/3A that can be selected. You could select the proper charge current according to the battery capacity. There is one LED indicating the charge status (ready to charge/charge in CC mode/charge in CV/ mode/charge finish) and four LEDs indicating each battery cell status (charge/discharge). In this case, we could know the charge process at any time easily through the LEDs status. The operation of the charger is also very simple. There are two toggle switches in the charger which can be used to selected battery type and charge current. After you power on the charger, select the battery type and charge current, connect the battery and charger with the balance board, the charger will start working.


  • Low Cost
  • Built in AC Power Supply
  • Wide AC Power Input Range (100-240V)
  • Charge in balance mode




  • Input Voltage AC Input: 100-240V, 50-60 Hz
  • Controls 2 Switches
  • Indication 4 LEDs for Balancing 1 LED for Charging Status
  • Case Material Plastic
  • Balance Current 200mA/cell
  • Maximum Cells LiPo/LiFe: 2-4 cells
  • Charge Current 1A, 2A, 3A
  • Charge Wattage 20W
  • Balance Cells 6 cells
  • Weight 176g
  • Dimensions (LxWxH) 69.4×110.7×40.5mm


SkyRCe4[SK100055] Manual (673.8 KiB)

Documents / Resources

SKYRC SK100055 E4 Balance LiPo Charger [pdf] Instructions
SK100055, E4 Balance LiPo Charger, SK100055 E4 Balance LiPo Charger, Balance LiPo Charger, LiPo Charger, Charger


Leave a comment

Your email address will not be published. Required fields are marked *