Skullcandy Venue User Manual

Skullcandy venue headphones

Skullcandy Venue User Manual

Skullcandy venue

Power ON - -OFF Power ON / OFF :

Power ON - OFF

 

Pairing Mode Pairing Mode :

Pairing

 

Pair New Device :

Pair New Device

 

Volume Volume Up :

Volume Up

Volume Down Volume Down :

Volume Dow

 

Play - Pause Play / Pause :

Play -- Pause

 

Track Forward Track Forward :

Track Forwards

 

Track Back Track Back  :

Track Back

 

Answer and End Phone Calls Answer and End Phone Calls  :

Answer and End Phone Call

 

Answer and End Phone CallsActivate Voice Assistant :
Activate Voice Assistant

 

Charge Charge :
Charging

 

Note: Rapid Charge : 10 Minutes = 5 Hours

Check Battery Life Check Battery Life :

Check Battery Life

 

Power ON - -OFF ANC – OFF  :

ANC OFF

 

Power ON - -OFF ANC ON :

ANC ON

Volume Monitor Mode ON / OFF :

Monitor Mode ON - OFF

 

Tile Enabled Download the App :

Tile Enabled Download the App

 

Pair Tile :

Pair Tile

 

Bluetooth function Disable with AUX Cable :

Bluetooth function Disable with AUX Cable

Answer and End Phone CallsMicrophone Function With AUX Cable :

Microphone Function With AUX Cable

Questions Visit www.skullcandy.com

ISED Statement
This device contains license-exempt transmitter(s) / receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1)This device may not cause interference. (2)This device must accept any interference, including interference that may cause undesired operation of the device.

ISED SAR Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

FCC SAR Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves abashed by the Federal Communications Commission (USA). These requirements net a SAR limit of g W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

The FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help. changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Made in China

Alart

FCC

Thanks

Questions about your Skullcandy Venue? Post in the comments!
Skullcandy Venue User Manual [PDF]

One Reply to “Skullcandy Venue User Manual”

Leave a Reply

Your email address will not be published. Required fields are marked *