USER MANUAL

Skullcandy Spoke

Auto Pair Mode

Auto Pair Mode
Pairing Mode

Auto Power- On

Auto Power- On
Power- On

Auto Power- Off

Auto Power- Off
Power- Off

Charge Earbuds

Charge Earbuds
Charge Earbuds

Charge Case

Charge Case
Charge Case

Pairing Mode

Left or Right Side * OFF Mode

Pairing Mode
Pairing Mode

Pair New Device

“Spoke”

Pair New Device
Pair New Device

Power-On

Left Side and Right Side

Power-On
Power-On

Power-Off

Left Side and Right Side

Power off
Power-Off

Play/Pause

Left Side or Right Side

Play/Pause
Play/Pause

Track Forward

Right Side

Track Forward
Track Forward

Track Back

Left Side

Track Back
Track Back

Volume Up

Right Side

Volume Up
Volume Up

Volume Down

Left Side

Volume Down
Volume Down

Answer/End

Left Side or Right Side

Answer/End
Answer/End

Activate Voice Assistant

Left Side or Right Side

Activate Voice Assistant
Activate Voice Assistant

Clear Paired Device

Left Side and Right Side
*Off Mode

Clear Paired Device
Clear Paired Device

Reset Device : Questions Visit: www.skullcandy.com

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.


This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from
    that to which the receiver is connected.
  • Consult the dealer or an experienced radionv technician for help.

ISED Compliance Statement

This device contains license-exempt transmitter(sVreceiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1 )This device may not cause interference.(2)This device must accept any interference, including interference that may cause undesired operation of the device.

ISED SAR Compliance Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the head.

Americas
Skullcandy, Inc.
6301 N Landmark Dr.
Park City, UT 84098 U.S.A.
Skullcandy.com

Questions about your Manual? Post in the comments!

Leave a comment

Your email address will not be published. Required fields are marked *