Skullcandy Riff User Manual


Riff Wireless

Skullcandy Riff User Manual

Skullcandy

Pairing Mode

Pair New Device

Power ON - OFF

Volume Up

Volume Down

Play Pause

Track Forward

Track Back

Answer - End

Active Voice Assistant

Charge

 

For Any Questions Visit: www.skulicandy.com

The FCC Compliance Statement
This device complies with part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this dicey must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and ban radiate radio frequency enemy and, if not installed and used in accordance with this instructions, may cause harmful interference to radio communications. However, there Is no guarantee that Interference will not occur In a particular.installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user Is encouraged to by to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment Into an outlet on a circuit different from that to which the receiver is connected.
—Consult the deal& or an experienced radio/TV technician for help.

The user is cautioned that any changes or modifications not expressly approved by the party responsible for compliance could vapid the user’s authority to operate the equipment.

ISED Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RS$(s). Operation is subject to the following two conditions: (1)This device may not cause interference. (2)This device must accept any interference, including interference that may cause undesired operation of the device.

ISED SAR Statement
This equipment complies with ISED radiation exposure limits forth for an uncontrolled environment. End user must follow. the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating In conjunction with any other antenna or transmitter. The portable device Is designed to meet the requirements for exposure tr, radio waves established by t5e ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during prod* certification for use when properly worn on the body.

Wireless Earphone
MODEL: S5PXW
Speaker Diver: 40mm
Impedance: 32 Ohms
THD <1 % @ 1 KHz
Voltage Regulation: 3.7v
Bluetooth® 4.1 Single Mode
Frequency Band: 2402 MHz — 2480 MHz
Maximum Power < 10dBm
Weight• 160g
FR Driver President: 40mm.

Skullcandy other marks are registered trademarks of Skullcandy, Inc. All rights reserved.

Hardware Version : 3.2
Software Version : 19

CONTAIN U-ion BATTERY.
BATTERY MUST BE RECYCLED
OR DISPOSES OF PROPERLY.

Americas Skullcandy, Ind.
6301 N Landmiark Dr.
Palk City, UT 84098, U.SA
Skulcandy.com

FCC

TR

PPB

Questions about your S5PXW Riff Wireless? Post in the comments!
S5PXW Riff Wireless User Manual [PDF]

Join the Conversation

3 Comments

  1. I have a TV set that I connected to a portable speaker that is Bluetooth capable, is it possible for my Riff wireless to connect to the speaker? This is important for me at bedtime .

  2. None of my devices can detect the headphones. I know they’re on and have used them before. How do I fix this?

Leave a comment

Your email address will not be published. Required fields are marked *