USER MANUAL

Skullcandy Push Ultra

Skullcandy Push Ultra

Auto Pair Mode

Auto Pair Mode
Auto Pair Mode

Auto Power- On

Auto Power- On
Auto Power- On
Auto Power- Off
Auto Power- Off

Charge Earbuds

Charge Earbuds
Charge Earbuds

Charge Case

ChargeCase
Charge Case

Pairing Mode

Pairing Mode

Pair New Device

Pair New Device

Power-On

Power-On

Power – Off

Power - Off

Play/Pause

Volume Down

Track Forward

Track Forward

Track Back

Track Back

VolumeUp

VolumeUp

Volume Down

Volume Down

Answer/End

Answer/End

Activate Voice Assistant

Activate Voice Assistant

Clear Paired Device

Clear Paired Device

Tile Enabled: Download the App

Bluetooth Enable Download the App

Pair Tile

Pair Tile

3EQ Modes

3EQModes

Questions Visit: www.skullcandy.com

Speaker Dnver: 12mm, Impedance: 320hms, 1HD <3%@1 KHz. Voltage Regulation:

Skulcandye,anc1 other Mari<s are registered trademark<s of Skullcandy, Inc. All rights

Maximum operating temperature 4S’C.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from
  • that to which the receiver is connected.
  • — Consult the dealer or an experienced radio/TV technician for help.

ISED SAR Compliance Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.

Leave a comment

Your email address will not be published. Required fields are marked *