Instruction Manual for PUREMATE models including: PM 760, PM 760 43 Inch Tower Fan, PM 760, 43 Inch Tower Fan, Tower Fan

43 INCH TOWER FAN-MANUAL

Download User Manual Here

PureMate 43-Inch Oscillating Tower Fan - PureMate Ireland

PDF preview unavailable. Download the PDF instead.

43 INCH TOWER FAN-MANUAL
MODEL NO: PM 760
INSTRUCTION MANUAL

Do Not Use This Tower Fan Until You Have Read This Entire Manual Thoroughly and Keep in a safe place for future reference.

Ensure that all safety precautions are followed when using electrical appliances for the proper operation of the safety device. This instruction booklet describes the safety precautions to be observed during operation to prevent injuries to yourself, other persons and damage to the device. The content not only is suitable for this product but also electrical appliances in general.
To avoid fire or shock hazard, plug the appliance directly into a 220-240V AC electrical outlet.
Disconnect the power plug before dismantling, assembling or before cleaning.
Keep unit away from heated surfaces and open flames.
To protect against electrical hazards, DO NOT immerse in water or other liquids. Do not use near water.
Children cannot recognize the hazards associated with the usage of electrical appliances. For this reason, always supervise children when they are near the unit.
Always unplug the tower fan before moving, cleaning or whenever the tower fan is not in use. Be sure to pull by the plug and not the cord.
NEVER drop or insert any object into any openings.

DO NOT run cord under carpeting. DO NOT use outdoors.
DO NOT cover cord with throw rugs, runners, or similar coverings.
DO NOT route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Please Call Customer Service for assistance.
DO NOT attempt to repair or adjust any electrical or mechnical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.
Do not operate the appliance with wet hands, in order to avoid damage.
DO NOT knock or shake the body of the tower fan when in use, otherwise it may cause the item to stop.
NEVER insert fingers, pencils or any other objects through the guards.
DO NOT use the appliance for any other purpose than its intended use.
The fan must not be used if the casing is damaged or open.

Remote controller
Body
Base Plastic nut NOTE
All the pictures in this manual are for explanation purpose only. Any discrepancy between the real object and the illustration in the drawing shall be subject to the real subject.

NOTE
Please place the machine on the package foam or other soft surfaces and invert it to avoid scratch mark when assembling the base.
1. Take out the two parts of the base from packing box. Then, align the centers
of the two parts of the base and place them in a crossed form. Rotate one of the two bases to align its hole site and make it stuck correctly.
2. Detach the plastic nut from the fan body.
3. Remove the pole, and then directly fix the fan body to the base with a plastic
nut.

ON/OFF: " "
Press this to switch on/switch off the fan.
OSCILLATION: " "
After the fan has started, press this key to select oscillation mode. The lights on the display can indicate fan oscillation mode.
TIMER: " "
Press to select the amount of time which you would like the device to run before it stops automatically. Increase in increments up to "0-1-2-3-4-5-6-7-0" hours.
SPEED: " " Press to adjust between 3 fan speeds.
- Low - Medium - High
MODE: " " Press to choose between 3 different modes:
- Normal Wind: The fan will blow continuously at any speed you select.
- SLEEP: " " The fan speed will gradually lower to Low over a 30
minute period. Speed cannot be manually adjusted. - BABY: " " The fan will imitate a gentle natural breeze, which will
increase and decrease wind power continuously.

Requires 2 X AAA 1.5V batteries. Used batteries must be safely disposed. Respect the polarity when inserting. Direct it to the front of the fan
AAA Battery. 1.5V
Battery
Battery not included in the packaging 1. Slide the battery compartment cover.

Fig 1
2. Insert the batteries, and make sure that the batteries are placed as shown in the Fig 2.
Fig 2
3. Slide back the battery cover.

NOTE

Fig 3

Use manganese or alkaline batteries of type "AAA". DO not use rechargeable

The fan requires little maintenance. Do not try to fix it by yourself. Refer it to qualified service personnel if service is needed.
1. Before cleaning and assembling, fan must be unplugged. 2. To ensure adequate air circulation to the motor, keep vents at the rear of the motor free of dust. Do not disassemble the fan to remove dust. 3. Please wipe the exterior parts with a soft cloth soaking a mild detergent. 4. Do not use any abrasive detergent or solvents to avoid scratching the surface. Do not use any of the following as a cleaner: gasoline, thinner. 5. Do not allow water or any other liquid into the motor housing or interior parts. 6. Be sure to unplug from the electrical supply source before cleaning. 7. Plastic parts should be cleaned with a soft cloth moisten with mild soap. Thoroughly remove soap film with dry cloth.

Incorrect operation of your appliance can lead to errors and malfunctions. The following tables contain possible causes and notes for resolving an error message or malfunction. It is recommended to read the table below carefully in order to save your time and money that may cost for calling to the service center.

Problem
The machine does not work properly after installed

Cause
· The power cable is not plugged in or has poor contact.

SSooluluttiioonn
Make sure the plug is properly inserted into the socket.

· The switch on the body is not turned Turn on the switch on the body. on.

The remote does not work

· The battery needs replacing.

Replace the battery.

Use the remote closer to the fan

· The remote is being used more than 5m away from the fan.

and make sure it is pointing directly

at the control panel.

~

Super Tech Health Limited 129 Shady Lane Great Barr Birmingham West Midlands B44 9ER United Kingdom
WWW.PUREMATE.CO.UK


Adobe PDF library 17.00 Adobe Illustrator 28.7 (Macintosh)