SHIMANO - Logo

User manual
(for 927A)
FCC ID: WY7-927A IC: 8117A-927A

SHIMANO INC.
Ver. 1.0.3 Jan. 18, 2021

927A Wireless Module

Since this module is not sold to general end users directly, there is no user manual of module.
For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the follow conditions.

  • Only for limbs device or the device separated from human’s body more than 15mm.

This module complies with the following standards:

  • FCC part 15 Subpart C

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
Since there is no space that indicates FCC ID on this module, FCC ID is indicated in a manual. If the FCC ID is not visible when the module is installed inside another device, then the module is installed must also display a label referring to the enclosed module.
The following information must be indicated on the host device of this module;

[for FCC]
Contains FCC ID: WY7-927A

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
*If it is difficult to describe this statement on the host device due to the size, please describe it in the user’s manual and also either describe on the device packaging or on a removable label attached to the device.

[for ISED(IC)]
Contains IC: 8117A-927A
The following statements must be described on the user manual of the host device of this module;

[for FCC]
FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has very low levels of RF energy.

[for ISED(IC)]
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF) Exposure rules as this equipment has very low levels of RF energy. But if use this device near the body, must keep the equipment at least 15mm or more away from the body.

[for FCC]

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Trade Name: SHIMANO
Model No.: 927A
Responsible Party: SHIMANO NORTH AMERICA BICYCLE, INC.
Address: One Holland, Irvine, California 92618, U.S.A.
Telephone: +1-949-951-5003
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Documents / Resources

SHIMANO 927A Wireless Module [pdf] User Manual
927A, WY7-927A, WY7927A, 927A Wireless Module, 927A, Wireless Module

Leave a comment

Your email address will not be published. Required fields are marked *