Shenzhen

Shenzhen Yaohui Technology LK206 Wireless Charging Station

Shenzhen-Yaohui-Technology-LK206-Wireless-Charging-Station

Diagram

 

Shenzhen-Yaohui-Technology-LK206-Wireless-Charging-Station-1

Shenzhen-Yaohui-Technology-LK206-Wireless-Charging-Station-2

Shenzhen-Yaohui-Technology-LK206-Wireless-Charging-Station-3

Indicator light description:

Remarks This product only has a working indicator for charging the mobile phone and an indicator for the TWS.

  1. When the power is on, the green light is on for 3 seconds and goes out
  2. Standby state: light off
  3. Charging status: the green light is always on
  4. FOD foreign body protection on mobile phone: the green light flashes
  5. Fully charged the green light is always on

Product Specifications:

Product name wireless charging station
Model LK206
Input 5V=2A 9V=2A 12V=1.5A
Output 5W 7.5W 10W
Interface Type Type-C

Correct Disposal Of This Product

Waste Electrical Electronic Equipment
This Marking shown on the product or its literature. indicate that it should not be disposed with other household wastes at the end of its working life.
To prevent possible harm to the environment or human health from uncontrolled waste disposal please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household user should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmental!y safe recycling Business users should contact their supplier and check the terms and conditions of the purchase contact. This product should not be mixed with other commercial wastes for disposal.

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,and(2)this device must accept any interference received, including interference that may cause undesired operation_
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions.may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co – located for operating in conjunction with any other antenna or transmitter.
This product is a stable and reliable cradle wireless charger.
Compatible with Qi 5W protocol , compatible with Samsung 1 OW protocol , compatible with Apple 7.5W protocol.

FQA:

If you’re experiencing interrupted or slow charging.check the following:

  1. The back of your phone should not have any metal,pop sockets, or credit cards,
  2. Put the phone in the center of the charging surface(this lets the charging coil in your phone line up with the one inside the wire!ess charger).
  3. Toe wireless charging coil on Sony phones is located slightly below center.
  4. Phone cases should be no thicker than 5mm for effective charging,
  5. Check whether the adapter is OC3 O/OC2 0 fast charger,

If you’re failing to charge your device,please try out the following:

  1. Please restart your cell phone and test with other USB cable.
  2. Please check whether the indicator turns on or not.
  3. Please check the Adapter is QC3.0/QC2.0 or not, iPhone original adapter does not match the wireless charger.
  4. Please check your Phone case thickness( <=5mm). Metal ring or Magnetic Pad will not be available.

If you’re using the recommended wireless charger with the QC3.0/QC2.0 Adapter and have removed any potential charging obstructions, but are still experiencing issues.try:

  1. Replacing the cable connecting the wireless charger
  2. Rebooting your phone.
  3. Unplug the adapter and reinsert.

Wireless Charger’s Compatible Phone Models and TWS Models:
Works flawlessly with virtually any Qi-enabled phone, Support Apple 2/3/pro, Samsung headset Samsung Galaxy Buds, Buds+, Buds Pro, Buds Live and other compatible earbuds with wireless charging case.

Documents / Resources

Shenzhen Yaohui Technology LK206 Wireless Charging Station [pdf] User Manual
LK206, 2A7M9-LK206, 2A7M9LK206, LK206 Wireless Charging Station, Wireless Charging Station

Leave a comment

Your email address will not be published.