Shenzhen-Mingfuxin-Furniture-Electric-Appliance-YY185-Embedded-USB-Fast-Wireless-Charger-logo

Shenzhen Mingfuxin Furniture Electric Appliance YY185 Embedded USB Fast Wireless Charger

Shenzhen-Mingfuxin-Furniture-Electric-Appliance-YY185-Embedded-USB-Fast-Wireless-Charger-product

Connect to Power

Shenzhen-Mingfuxin-Furniture-Electric-Appliance-YY185-Embedded-USB-Fast-Wireless-Charger-fig-1

System Specifications

  • / Model: YY185
  • Input: 100-240Vac / 50/60hz / 1A Max
  • Output: usb1 / 5V 3A 9V2A
  • Wireless Charging 15W Max
  • Receiving Distance: 2-6mm
  • Conversion Efficiency: ≥ 75%
  • Operating frequency: power port / 20k-50k Hz
  • wireless charging / 115k-205k Hz

Notes
Please pay attention to the following issues, otherwise, it may cause abnormal charging, high charging temperature, intermittent charging, or even not charging.

  1. USB interfaces have IC smart recognition Android phones and apple phones.
  2. Please put the device at the center or charge area to ensure stable charging .(as picture shows)
  3. The wireless port charging distance is 2-8mm, please remove the phone case if the thickness is up to 3mm and above.
  4. The wireless port charging has overheating protection. when the temperature reaches 60degrees, the charging will be stopped automatically. Other way , is charging keeps continuing.
  5.  Do not place metal, magnet and other accessories near the row plug, which will interfere with charging.
  6.  The lower temperature the faster charging speed. The charging speed is faster in winter than in summer.
  7.  Do not charge in high temperature and humidity to avoid damage the circuit.
  8.  Put it at the place that children can’t reach to avoid to unnecessary accidents.

FCC warning

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body

Documents / Resources

Shenzhen Mingfuxin Furniture Electric Appliance YY185 Embedded USB Fast Wireless Charger [pdf] User Manual
YY185, 2A68H-YY185, 2A68HYY185, YY185 Embedded USB Fast Wireless Charger, Embedded USB Fast Wireless Charger

Leave a comment

Your email address will not be published.