Item No. 207670

Thank you for purchasing the Sharper Image Automatic Clamping Wireless Car
Charger. Please take a moment to read this guide and store it for future reference.

FEATURES

  • Compatible with all Qi-enabled devices for fast wireless charging, including iPhones and Galaxy/Android devices
  • Clips easily to your car air conditioner vent
  • Rotates easily for horizontal or vertical viewing
  • LED indicator light
  • Overload protection keeps your device safe
  • Overheat protection for additional safety

IDENTIFICATION OF PARTS
A. Automatic retractable arms
B. Intelligent sensing area
C. Phone cradle
D. Touch sensor
E. Air vent clip
F. LED status indicator
G. USB port
H. USB power cable (not shown)

INSTALLING THE MOUNT

  1. Place the tightening ring over the vent clip ball joint.
  2. Place the ball joint into the socket on the back of the car mount.
  3. Screw the clip ring over the socket until the mount is securely attached to the vent clip.
  4. Squeeze the vent clip button until the clamp opens.
  5. Clamp the mount onto your car air conditioner vent.
  6. Adjust the mount angle by loosening the ball joint, then re-tighten the clip ring.
  7. Connect the USB power cord to the USB-C port of the device.
  8. Plug the other end of the power cord into your car’s USB port or car charging adapter (car charging adapter not included).
  9. The LED indicator light will be BLUE when the device is ready to charge your Qi-enabled phone.

CHARGING YOUR DEVICE

  1. Hold your phone 2” to 7” from the device. The arms will automatically open. Rest your phone in the phone cradle as the arms automatically close to clamp your phone.
  2. At this point, wireless charging will automatically begin. The GREEN LED charging light will be on.
  3. To remove your phone, tap the touch sensor on the back of the device to open the arms.

NOTE: This device has numerous safety features including overheat protection. In the event of overheating, it will shut off automatically. Unplug the device and let it cool down. Then, re-connect the device to resume charging.

WARNING

  • Do not use this device for anything other than its intended purpose.
  • Keep away from heat sources and direct sunlight.
  • Operational temperature range: 32°F to 95°F.
  • Do not let this device come in contact with water.
  • If you have an electrical implant such as a pacemaker, consult your physician before using this product.
  • Do not place a magnetic stripe card (credit card, ATM card, ID, etc.) near this product.
  • Do not alter or attempt to repair this device. There are no user-serviceable parts.
  • Use only the cable that came with this device.
  • Keep out of reach of children at all times.

WARRANTY AND CUSTOMER SERVICE

Sharper Image branded items purchased from SharperImage.com include a 1-year limited replacement warranty. If you have any questions not covered in this guide, please call our Customer Service department at 1 (877) 210-3449. Customer Service agents are available Monday through Friday, 9:00 a.m. to 6:00 p.m. ET.

 

Automatic Clamping Wireless Car Charger Manual Optimized

Automatic Clamping Wireless Car Charger Manual Original

Leave a comment

Your email address will not be published. Required fields are marked *