Sharktooth Prime EVO Universal Plug and Play Intercom System User Guide
Sharktooth Prime EVO Universal Plug and Play Intercom System

DESCRIPTION – LEGENDA

Description Legenda

Symbol
Button-/Button+ OPERATION
Symbol
Press X sec.
Symbol
Press X times
Symbol
Sound alert
AUDIO FEEDBACK

VISUAL FEEDBACK
Symbol
Blue led blinking
Symbol
Red led blinking
Symbol
Red/blue led blinking
Symbol
Purple led
Symbol
Steady blue led

Steady red led

POWER ON

Power on
Press 3 sec.
Power on
Led Blinking
Power on
“Power on”
Power on
Battery status

PAIRING TO PHONE/GPS

Status: power off

Pairing to Phone
Press 4 sec.

Pairing to Phone
Led blinks alternately

Pairing to Phone
Searching Bluetooth device on your phone. If needed, enter PIN code (0000).

Pairing to Phone
Four led blinking’s

Power on
“Pairing successful”

Power on
“Device connected”

POWER OFF

Power off
Press 3 sec.
Power off
Led Blinking
Power on
“Power off”

PAIRING ANOTHER SHARKTOOTH PRIME

Status: Both units powered on

Both units powered on
Press 5 sec. on both devices

“Pairing”

Both units powered on
Led blinks alternately on both devices

Both units powered on
Three led blinkings on both devices

Power on
“Pairing successful”

PAIRING TO A DIFFERENT MODEL/BRAND UNIT

Status: Both units powered on

Both units powered on
Press 5 sec.
Both units powered on
Led blinks alternately
Both units powered on
Follow the “phone” pairing procedure
Power on
“Pairing”

Both units stop fl ashing
Power on
“Pairing successful”

OPEN/CLOSE INTERCOM

Status: units on and paired

units on and paired
Press once
Power on
“Beep”
units on and paired
Led blinks: audio active

RESET ALL PAIRINGS

Status: power off

power off
Press 7 sec.
power off
Steady led for 3 sec.
Power on
“Beep”

VOICE CALL

Status: unit on and connected to a phone

Voice Call
Press twice
Voice Call
Voice assistant (Google assistant, Siri)
Voice Call
Press twice to end the call

Note: Double click on + Button -> Redial.

ANSWER A CALL

Status: phone rings

phone rings
Press once to answer a call
phone rings
Press once to end a call
phone rings
Press 3 sec. to reject a call

Note: if the automatic reply is activated, after 8 seconds the call automatically starts.

VOLUME ADJUSTMENT

Status: while listening to an audio source (intercom, music, phone call…)

Volume Adjustment
Keep pressed to increase the volume
Volume Adjustment
Keep pressed to decrease the volume

MUSIC

Status: unit on and connected to the phone

Volume Adjustment
Select a music APP from the phone
Music
Press once Play/Pause
Music
Blinking
Music
Press twice Song forward
Music
Press twice Song backward

CHANGE LANGUAGE

unit on
Keep pressed for more than 7 seconds
Power on
“Battery status” in the various languages. Release + button to select the desired one.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

SHARK S.A. Z.A.C. de la Valentine 110, route de La Valentine 13396 MARSEILLE Cedex 11 – FRANCE
Tél. : +33 (0)4 91 18 23 23
Fax : +33 (0)4 91 35 29 23
e-mail : contact@shark-helmets.com
Read the instructions carefully before installation and use.

Produced or imported by:
MIDLAND EUROPE srl Via R. Sevardi 7 – 42124 Reggio Emilia – Ital Distributed in Canada by: GAMMA POWERSPORT 100 HUNTER VALLEY RD L3V0Y7 ORILLIA (ON)

To download the complete user manual please visit
www.shark-helmets.com

Sharktooth Logo

Documents / Resources

SHARK Sharktooth Prime EVO Universal Plug and Play Intercom System [pdf] User Guide
Sharktooth Prime EVO Universal Plug and Play Intercom System, Sharktooth Prime EVO, Universal Plug and Play Intercom System, Plug and Play Intercom System, Play Intercom System, Intercom System

References

Leave a comment

Your email address will not be published. Required fields are marked *