Shark NV150 Series Navigator Swivel Pro Complete Upright Vacuum FAQs

Press the release button on the back of the handle and gently lift it off the wand. Add an accessory and begin cleaning.

Press the Wand Release button and pull up on the wand to detach it from the pod.

To turn the vacuum off, press the red power button on the vacuum pod to O, power off.

Make sure the unit is unplugged. 
Pre- Motor Filters
Remove the dust cup and pull the flat foam filter out from the motor housing. Then remove the felt filter using the small ribbon pull-tab. Rinse filters thoroughly in lukewarm water until the water runs clear. Squeeze out excess water and let air-dry completely for at least 24 hours before replacing. Do not place filters in the dishwasher or washing machine. To replace inside the vacuum once dry, put the felt filter in first, then add the foam filter.
Hepa Filter
Remove the filter cover from the front of the vacuum by pulling the latch from under the motor housing. Remove the HEPA filter cartridge, pull off the pre-HEPA filter and rinse them both under lukewarm water, dirty side down, until the water runs clear. Allow the filters to air-dry completely for 24 hours. Once the filters are dry, snap them back together and place them back into the vacuum, then replace the cover by lining up the tabs on one side and swinging the door securely closed until it clicks into place.

Press the release button on the top of the dust cup handle. Tilt the dust cup and lift it away from the vacuum body.
Hold the dust cup over the trash and press the bottom door release button on the front of the dust cup. The bottom lid will drop open. Tap gently to empty contents. Close the lid, pressing it until it clicks into place.
 The dust cup should be emptied each time you vacuum and periodically during cleaning, when it appears full

With scissors, carefully cut away any hair wrapped around the brushroll. Check for any debris in the nozzle and remove if needed. brushroll. Check for any debris in the nozzle and remove if needed.

The Shark Navigator Swivel Pro Complete Upright Vacuum is manufactured by our high-quality vacuum manufacturing partners in China.

The Shark Navigator Swivel Pro Complete Upright Vacuum is produced with a combination of durable plastics, like ABS and PP, along with some metal and rubber components.

The vacuum weighs less than 15 lbs

The vacuum is 45.27 inches tall, 9.8 inches long, and 12 inches wide.

0.87 Quarts

The cord is 25 feet long.

120 Volts

700 Watts

5.8 Amps