Shanghai GD UNI PAD FLIP Universal Wireless Keypad

GETTING STARTED

Locate the LEARN button on the garage door opener.
NOTE: Your garage door opener may look different.

PROGRAM THE INITIAL PIN

Before You Begin
Programming is time-sensitive.

1. Write a 4-digit PIN# of your choice in steps 4 and 6.
2. Find and write your opener ID# from the list below to use in step 4.
3. Press and hold the and# buttons until the keypad stops flashing.
4. IMPORTANT: You have 10 seconds to complete this step. If the keypad light turns off before completing this step, go back to step 3.
   Enter your 4-digit PIN  and press#. Enter the opener ID  and press#.
   
5. Press and quickly release the LEARN button on the garage door opener.
   
6. ENTER  your 4-digit PIN  and press the 0 key.
   NOTE: For Genie and Overhead Door units, press the Okey twice.
7. Test by entering your 4-digit PIN, then press and hold the Okey until door activates.

CHANGING AN EXISTING PIN

1. Enter the existing 4-digit PIN#, and press
2. Enter a new 4-digit PIN and press
3. Test by entering your new 4-digit PIN# and press the Okey

BATTERY

Replace the 9-Volt battery when the keypad light becomes dim or does not light up. Slide cover up, remove battery cover, and replace battery.

INSTALLATION

Install out of reach of small children at a minimum height of 5 feet (1.5 m) above floors, landings, steps or any other adjacent walking surface, and away from ALL moving parts of door. Secure keypad to a smooth surface. Mount the keypad out of the path of the moving garage door, but within sight of it (4″ [10 cm] clearance is needed for the cover).

1. At the keypad cover bottom, pinch sides and firmly slide the cover from the keypad.
2. Remove the battery cover to show mounting holes.
3. Remove the battery and mount the keypad using screws provided.
4. Reassemble the battery cover and keypad cover.

FCC

Please take attention that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation

Documents / Resources

Shanghai GD UNI PAD FLIP Universal Wireless Keypad [pdf] User Guide 2ANHJGDUNIPADFLIP, gdunipadflip, GD UNI PAD FLIP Universal Wireless Keypad, GD UNI PAD FLIP, Universal Wireless Keypad, Wireless Keypad, Keypad

References

• User Manual