Sensata DP700 MK2 Digital Readout System User Guide
For the complete manual please download from:
http://newall.com , Click Technical Support to access the download page.
Warnings
The mains supply is connected into a switch mode power supply (separate from your DP700) via a
detachable supply cord supplied. If another supply cord is used, it must have fitted a C5, 10A, EARTHED mains connector with a cord rated for at least 10A.
If a mains plug is not already fitted to the supply cord or is of the wrong type, then a suitable EARTHED plug should be used which complies with the relevant specifications for plugs and socket outlets.
You can only use the DP700 with Newall Spherosyn and Microsyn analogue encoders.
Unit only to be serviced by Newall qualified personnel or authorised alternatives.
Turn off the power by disconnecting the power supply connector before you connect the encoder(s)
Technical Specification
Environmental
Operating Temperature Storage Temperature
-10°C to 50°C -20 to 70°C
Environmental Conditions – IP40 (Stand Alone) IP54 (Panel Mount)
Relative Humidity – maximum 95% for temperature up to 31°C
Disposal
At the end of it’s life, you should dispose of the DP700 in a safe manner applicable to electronic goods.
The case work is suitable for recycling. Please consult local regulations on disposal
Electrical
EU Directive 73/23/EEC (Low Voltage
Directive)
BS EN 55022:1998 Class B
BS EN 55024:1998
Input to Power Supply Unit (Supplied)
100-240V (47-63Hz)
External switch-mode
Output voltage 15VDC
Input Voltage to DP700
15-24VDC ±10%
Conforms to Low Voltage Directive
Note: Newall Measurements Systems reserves the right to change specifications without notice.
Connections
Understanding the Keypad
| Axis Selection Key |  | Numeric Keys |  | Enter Key |  | Clear Numeric Entry |  |
| Center Find |  | Undo Key |  | Digifind / Reference |  | Switches between Zero and Axis Preset modes |  |
| Switches between Absolute and Incremental modes |  | Switches between Inch and mm display |  | Information selection (scrolls through options on Message display) |  | Function Menu Key |  |
| Function Navigation Keys |  | Sleep key |  |
Zero an Axis in Zero Mode
Ensure DP700 is in Zero Mode
of Axis 1, 2 or 3
Zero an Axis in Set Mode
Ensure DP700 is in Set Mode
Preset an Axis
Ensure DP700 is in Set Mode
ENTERING SETUP
Until display shows
display shows
SETTING UP THE UNIT
Must be set to match encoders on the machine
AMERICAS Newall Electronics Inc. 1803 OBrien Rd Columbus, OH 43228
Tel: +1 614 771 0213
sales@newall.com
newall.com
REST OF WORLD
Newall Measurement Systems,Ltd. Business Park, Unit 1 Wharf Way Glen Parva, Leicester LE2 9UT
United Kingdom
Tel: +44 (0) 116 264 2730
sales@newall.co.uk
newall.co.uk
Documents / Resources
 | Sensata DP700 MK2 Digital Readout System [pdf] User Guide DP700 MK2 Digital Readout System, DP700, MK2 Digital Readout System, Digital Readout System, Readout System, System |
