SENNHEISER Control Cockpit EW-DX Control Monitoring and Firmware Updates User Guide

SENNHEISER Control Cockpit EW-DX Control Monitoring and Firmware Updates

Sennheiser Control Cockpit: EW-DX control, monitoring and firmware updates
To control, monitor and perform firmware updates for EW-DX you will need our Sennheiser Control Cockpit software. This document outlines how to install and configure Control Cockpit and update your EW-DX products.
Installing Control Cockpit
The installation file of the Sennheiser Control Cockpit software can be downloaded from the Sennheiser Control Cockpit product page: Control Cockpit audio software | Sennheiser
Follow these simple steps to have the software installed:

• Save the downloaded installation file SennheiserControlCockpitInstaller.exe on the host PC
• Start the installation process
• Click on Options if you want to change to the standard settings of the installation
• Adjust the settings as desired and click on OK
• Please note to include http:// for the proxy URL
• The installation window will be displayed again
• Agree to the license terms and conditions
• Click on Install
• The Sennheiser Control Cockpit will be installed. Afterwards, the following dialog is displayed:
• Restart the host PC to start using Control Cockpit
• Before using Control Cockpit for the first time you need to enter your Activation Key
• Click on Get your activation key to open the following address: www.sennheiser.com/controlcockpit-registration
• Click on Activate after you have received your activation key

For further instructions on how to use Sennheiser Control Cockpit, please refer to the following manual: Sennheiser Control Cockpit – Software Manual

Updating EW-DX

Once Sennheiser Control Cockpit software is installed and activated, you can proceed to update EWDX devices.

Please follow these simple steps:

• Connect EW-DX to the same network as your PC
• EW-DX will be automatically discovered by Control Cockpit
• Go to the device page and select the latest available firmware (firmware 1.1.3 as of November 2022), accept the license agreement, and update your receiver
• Your EW-DX has been successfully updated

For conformity, consistency and compatibility reasons, we strongly recommend always upgrading the system to the new release.

Documents / Resources