SDC-logo

SDC ED4200 Corbin Russwin Electric Latch Retraction Kit

SDC-ED4200-Corbin-Russwin-Electric-Latch-Retraction-Kit-product

INSTALLATION

Retrofit Installation Note: 42″ or 48″ exit devices that have been modified to fit a 36″ or smaller opening, may not have the required space to fit the standard E. L. R. assembly. Always verify the distance from the end of the touchpad to the end rail, and if necessary, consult with the factory for appropriate selection.
Remove the End Cap, Mounting Plate, Cover, Cover Plug, Rail Housing and Dogging.

SDC-ED4200-Corbin-Russwin-Electric-Latch-Retraction-Kit-fig-1

Replace Housing Cover, Cover with Plug, End Cap and the End Cap Cover.

SDC-ED4200-Corbin-Russwin-Electric-Latch-Retraction-Kit-fig-2

When retrofitting to existing vertical rod devices, adjustment of the rods is required for proper operation of the Electric Latch Retractor. Once the unit is properly installed, energize it so the latch is dogged down, then reconnect the vertical rods to the device and make the proper adjustments.

SDC-ED4200-Corbin-Russwin-Electric-Latch-Retraction-Kit-fig-3

Documents / Resources

SDC ED4200 Corbin Russwin Electric Latch Retraction Kit [pdf] Instruction Manual
ED4200, Corbin Russwin Electric Latch Retraction Kit, ED4200 Corbin Russwin Electric Latch Retraction Kit, Russwin Electric Latch Retraction Kit, Electric Latch Retraction Kit, Latch Retraction Kit, Retraction Kit, Kit

Leave a comment

Your email address will not be published.