Schreder PF5LEDKIT Tunnel Retrofit Solution
Product Overview
- Led colour code 740 NW
- Light source energy efficiency class – High power C
INSTALLATION
INPUT connection
Connector position: LEFT 
SAFETY INSTRUCTIONS
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. Always switch off the power prior to installation, maintenance or repair activities.
RISK GROUP
RISK GROUP 2 – CAUTION! Hazardous optical radiation may be emitted from this product. Do not stare at the luminaire when operating as it may be harmful to the eyes. The luminaire should be positioned so that prolonged staring at the luminaire at a distance of less than 0.94m is not expected.
ENERGY EFFICIENCY
This product contains a light source of an energy efficiency class G or higher or see table on the first page.
PVC INSULATION AND Y CONNECTION
In the case of PVC insulated mains cable, the installer MUST ensure that the WHOLE cable is protected against climatic conditions, especially UV rays and rain, by making sure that the cable is contained inside the luminaire and pole. Y-connection: In case of damage to the wire, it has to be replaced only by the manufacturer, distributor, or by an expert, to avoid risks.
MORE INFORMATION
FAQs
- Q: What should I do if the product emits harmful optical radiation?
- A: Avoid visual contact with the light source during operation. Position the luminaire to prevent prolonged visual contact from a distance less than 0.94m.
- Q: How should the main cable be secured?
- A: Screw the mains cable to the pluggable terminal block and cut excess wire length if necessary.
Documents / Resources
 | Schreder PF5LEDKIT Tunnel Retrofit Solution [pdf] Installation Guide PF5LEDKIT Tunnel Retrofit Solution, PF5LEDKIT, Tunnel Retrofit Solution, Retrofit Solution |