M4 Stand and Hub with NVMe Enclosure
MAC MINI M4 STAND & HUB
WITH NVME ENCLOSURE
QUICK GUIDE
INSTALLING NVME SSD
Remove the SSD enclosure cover on the bottom of the
stand.
Before installing NVMe SSD, first apply the included thermal
tape.
The side with the blue film should be in contact with the
SSD. The clear film adheres to the enclosure
Insert the SSD at a slight angle (35-45°) and ensure it is fully
seated in the PCIe slot.
Important: This stand is not compatible with SSDs that have
pre-installed heat sinks or are double-sided.
Secure the SSD using the included screwdriver and screw.
Tip: To prevent stripping the screw, do not overtighten
Carefully reattach the enclosure cover: insert the side clips
first, then slide the door into place.
Flip the stand back over.
Place the stand on a flat surface and use the USB-C cable to
connect to your M4 Mac Mini.
Supports Mac Mini (M4, 2024). Does not support M2, M1, or
2018 Mac Mini or Mac Studio models.
Easily access the power button through the cutout.
PORTS AND CONNECTORS
SD 4.0 Card Reader (up to 312 MB/s)
High-speed data transfer for SD cards.
Insert the card with the label facing up and the pins facing
down.
Two USB-A 10Gbps (up to 1250 MB/s)
Two high-speed data transfer ports for external drives.
These ports do not support charging or CD drives,
including the Apple SuperDrive.
USB 2.0 Port (up to 60 MB/s)
Ideal for low-power devices and peripherals (e.g., USB dongles, wired keyboards).
This port does not support charging or CD drives, including the Apple SuperDrive.
Documents / Resources
 | SATECHI M4 Stand and Hub with NVMe Enclosure [pdf] User Guide M4, M4 Stand and Hub with NVMe Enclosure, Stand and Hub with NVMe Enclosure, Hub with NVMe Enclosure, NVMe Enclosure |
