SALTER SAP220688 Loud Beeper Electronic Timer Instruction Manual

SALTER SAP220688 Loud Beeper Electronic Timer

Safety Instructions

BATTERY WARNING: KEEP OUT OF THE REACH OF CHILDREN.
This product is not a toy. This product contains no user serviceable parts. Only a qualified electrician should attempt repairs. Do not place, store or use the product near direct sunlight or direct heat sources or in a damp/high humidity environment. This product is intended for domestic use only.

Battery Safety
This product is supplied with 2 x AA batteries (included). Only batteries of the same or equivalent type as those recommended should be used with this product. Batteries are to be inserted with the correct polarity. Exhausted batteries should be removed from the product to avoid leakage.

Care and Maintenance

Wipe the exterior of the timer with a soft, damp cloth and allow it to dry thoroughly. Never immerse the timer in water or any other liquid. Do not use harsh or abrasive cleaning detergents or scourers to clean the timer, as this could cause damage.

Before First Use

Remove the plastic isolator tab from the battery compartment (if present) prior to use. Make sure the batteries are inserted following the correct polarity.

Setting the Timer

• STEP 1: Press ‘HOUR’ to set the hours. Press ‘MIN’ to set minutes. Press ‘SEC’ to set seconds. Press and hold the buttons to advance the digits quickly.
• STEP 2: Press ‘START/STOP’ to start the timer countdown.
• STEP 3: Press ‘START/STOP’ again to pause or resume timing.
• STEP 4: At ‘O:OO:OO’ the alarm will sound for 1 minute.
• STEP 5: Press ‘START/STOP’ to silence the alarm and recall the last time set. STEP 6: When the timer has stopped press ‘MIN’ and ‘SEC’ simultaneously to reset the timer to zero.

Using the Count Up Feature

• STEP 1: When the timer displays ‘O:OO:OO’ press ‘START/STOP’ to start count up.
• STEP 2: Press ‘START/STOP’ again to pause or resume timing.
• STEP 3: When the timer has stopped press both ‘MIN’ and ‘SEC’ at the same time to reset the timer to zero.

To Set the Volume Level

The volume switch is located on the right-hand side of the timer. Slide the volume switch to adjust the level of volume. The display will indicate the volume level selected.

Specifications

• Product code: 355
• Display: LCD
• Battery: 2 x AA batteries (included)

Disposal of Waste Batteries and Electrical and Electronic Equipment

This symbol on the product, its batteries or its packaging means that this product and any batteries it contains must not be disposed of with household waste. Instead, it is the user’s responsibility to – hand this over to an applicable collection point for the recycling of batteries and electrical and electronic equipment. This separate collection and recycling will help to conserve natural resources and prevent potential negative consequences for human health and the environment due to the possible presence of hazardous substances in batteries and electrical and electronic equipment, which could be caused by inappropriate disposal. Some retailers provide take-back services which allow the user to return exhausted equipment for appropriate disposal. It is the user’s responsibility to delete any data on electrical and electronic equipment prior to disposal. For more information about where to drop batteries, electrical and electronic waste off, please contact the local city/municipality office, household waste disposal service, or the retailer.

Documents / Resources