S and B Filters 82-1004 Map Sensor Spacer Kit
BEFORE YOU START
Thank you for purchasing your new S&B Filters Map Spacer. If at any time you need additional assistance with installation or have any other questions or comments, feel free to call our customer support team at 909-947-0015.
REQUIRED TOOLS
- 7mm Wrench/Socket
- 8mm Wrench/Socket
Approx. Install Time: 15 min
INSTALLATION INSTRUCTION
STEP 1
Unplug the map sensor harness.
STEP 2
Remove the map sensor bolt using a 7mm wrench. Be careful not to drop this bolt in your engine bay. Access is limited on the 2017-2019 trucks so the shorter the wrench the better.
STEP 3
Remove the map sensor from the manifold. Pull up and wiggle on the spacer to get it free of the manifold.
STEP 4
Install the provided O-ring onto the S&B Map sensor spacer and install the spacer into the manifold. Make sure the bolt hole is lined up with the threaded insert in the manifold.
STEP 5
Install the map sensor with the original o ring into the S&B spacer. Again, make sure the bolt hole is lined up with both the hole in the spacer and the threaded insert in the manifold.
STEP 6
Apply thread locker to the new bolt included with the S&B kit.
STEP 7
Thread the bolt in as far as possible by hand and then use a 8mm wrench to snug it up and complete the last few rotations. Be careful not to overtighten the bolt.
STEP 8
Reconnect the map sensor harness.
Documents / Resources
![]() | S and B Filters 82-1004 Map Sensor Spacer Kit [pdf] Installation Guide 82-1004, 82-1004 Map Sensor Spacer Kit, 82-1004, Map Sensor Spacer Kit, Sensor Spacer Kit, Spacer Kit, Kit |