Ruidla JS-020 Fabric Shaver Defuzzer, Electric Lint Remover
Product structure
- Protective cover
- Mesh
- Blade
- Blade bin
- Switch
- Indicator light
- Charging port
- Lint collection
Using Methods
Charging
- Charging in a 5-35 degree environment.
- Use the power cable connect USB port or 5V adapter(fig.1).
- When lint remover is charging, the light is red. Charging time is about 8 hours.
Do not use beyond 5V adapter charging which will hurt this product. For extended service life, please disconnect the power after fully charging.
Operating
Turn on the switch(FIG.2)
Efficiency of the device and the result of the fabric repair(fig.3)
When the efficiency of the device becomes low, open the screen cover anti-clockwise carefully take out the cutting blade, then clean the blade and also the inner compartment of the device using a soft brush.
Please clean the product after you used it.
The appliance’s package is made from environmentally friendly material and can be disposed of at your local recycling plant.
Clean and maintain
- Please ensure the product switch closed
- Take off the lint container and use the brush clean it(fig.1).
- Take off the mesh, please hold the blade between the plastic area, not on the blades to remove them.(fig.2.3).
Product specifications
WELCOME TO CONTACT US
Service mailbox:
averybaronkhy@yahoo.com
Frequently Asked Questions
Please kindly refer to the user manual.
It takes about 8 hours to fully charge.
It lasts for about 60 minutes.
The dimensions are 14.5*7*3.5cm.
It is powered by electricity.
Yes, there is a one-year warranty on this product.
A particularly slippery fabric is satin. I would be concerned that the fabric would be snagged by the circular blades and ruined.
The charge voltage is 5V, and the charge line is 40 cm long. 2.4V/3V is the rated voltage and power. The battery may be recharged 500 times. 8 to 10 hours when fully charged, with 30 to 40 minutes of free time. The rotational rate is 6500 r/m. These are all the product details taken directly from the box’s side.
It normally takes 40 minutes to fully charge, which might take 8 to 10 hours.
No separate battery charger is present. A power cord is provided to connect to a USB port or a 5V power source.
Although I have not exactly measured it, it is not at all short, unlike many that I have seen, which is a hassle. It’s controllable and won’t tangle as much. When creating this product, the creators must have taken your issue into account. A longer one would need an extension cord, which is acceptable as well. I hope I was able to address your worry.
In all honesty, it lacks sufficient strength for the sherpa’s thickness. You won’t get satisfying outcomes from it.
Yes, you can shave off any fabric that begins to ball up. The real clothing isn’t cut too deeply; only what is hoisted up is. If you are still worried, test it first in a discreet place or on different garments to see how it reacts. I used it on workout pants where the fabric rubbed against itself without any issues.
If it doesn’t, I make sure the garment is flat and alter the unit’s angle. Never had an issue
