Innovo Deluxe iP900AP Fingertip Pulse Oximeter User Manual

1. Продукт закончилсяview

The Innovo Deluxe Fingertip Pulse Oximeter is designed to provide accurate measurements of blood oxygen saturation (SpO2) and pulse rate (PR) at your fingertip. This device is equipped with advanced features such as a Plethysmograph and Perfusion Index (PI) to enhance the reliability of readings, especially in conditions of low blood perfusion. Its compact and user-friendly design makes it suitable for sports enthusiasts, aviators, and home use.

Image: Innovo Deluxe iP900AP Fingertip Pulse Oximeter, showing the device with its display on, indicating SpO2 and pulse rate.

Основные характеристики:

• Точно и надежно: Improved LED and sensor for SpO2 and pulse rate measurement even at low blood perfusion.
• Plethysmograph and Perfusion Index (PI): Features that ensure accurate readings and inform you of pulse strength. A PI value less than 0.2% indicates potential issues like cold hands or improper positioning.
• Upgraded Hardware and Software: Includes auditory alarm, pulse detection beeps, and adjustable display brightness.
• Универсальное использование: Ideal for climbers, skiers, bikers, aviators, and for tracking SpO2 and pulse rate before or after exercise.
• Готово к использованию: Comes with 2x AAA batteries and a lanyard for immediate convenience.

Image: Labeled diagram of the Innovo Pulse Oximeter, pointing out the Lanyard Loop Hole, Blood Oxygen Saturation Level, Pulse Rate, Plethysmograph, Battery Level Indicator, Perfusion Index, and One-Button Operation.

2. Настройка

2.1. Установка аккумулятора

1. Откройте крышку батарейного отсека, расположенную на задней панели устройства.
2. Insert two AAA batteries into the compartment, ensuring correct polarity (+ and -).
3. Плотно закройте крышку батарейного отсека.

2.2. Крепление шнурка

The device comes with a lanyard for easy carrying and to prevent loss. Follow these steps to attach it:

1. Insert the loop of the lanyard into the lanyard holes on the device.
2. Thread the lanyard strap through the loop.
3. Pull the lanyard strap until it is tight and secured.

Image: Step-by-step diagram illustrating how to attach the lanyard to the pulse oximeter.

3. Инструкция по эксплуатации

3.1. Проведение измерения

1. Insert one of your fingers completely into the rubber opening of the oximeter with the nail surface upward.
2. Press the power button on the front panel to turn on the oximeter.
3. Во время измерения держите руку неподвижно. Движение может повлиять на точность.
4. Read the measured data from the display screen. The SpO2 (blood oxygen saturation) and PRbpm (pulse rate) values will be shown. The Plethysmograph waveform and Perfusion Index (PI) will also be displayed.
5. The device will automatically power off after approximately 8 seconds if no finger is detected, conserving battery life.

Image: A person demonstrating the use of the Innovo Pulse Oximeter by placing it on their finger.

3.2. Интерпретация показаний

• SpO2 (%): Это указывает на процентtage of oxygen in your blood. Normal healthy adult values are typically between 95% and 100%.
• PRbpm: This is your pulse rate, measured in beats per minute.
• Plethysmograph: The waveform displayed on the screen. Each wave corresponds to a heartbeat, and the amplitude indicates the amount of blood detected. A stable, consistent waveform suggests a reliable reading.
• Perfusion Index (PI): This value reflects the strength of your pulse signal. A PI value below 0.2% may indicate that your finger is too cold or improperly positioned, potentially affecting reading accuracy. Warm your finger and reposition it directly under the LED lights for better results.

3.3. Display Orientation and Settings

The display orientation can be changed by briefly pressing the power button while the device is on. This allows for viewing the readings from different angles. The device also features adjustable alarm limits for SpO2 and pulse rate, and brightness settings, accessible through a menu by holding down the power button.

4. Техническое обслуживание

4.1. Уборка

To clean the oximeter, wipe the surface with a soft cloth dampened with medical alcohol (70% isopropyl alcohol). Do not immerse the device in water or any cleaning solution. Ensure the device is completely dry before reuse.

4.2. Замена батареи

Когда индикатор заряда батареи на дисплее показывает низкий уровень заряда, незамедлительно замените батареи, чтобы обеспечить точность показаний. Следуйте инструкциям по установке батарей, приведенным в разделе 2.1.

4.3. Хранение

Store the oximeter in a cool, dry place away from direct sunlight, extreme temperatures, and humidity. If the device will not be used for an extended period, remove the batteries to prevent leakage and damage.

5. Поиск Неисправностей

If problems persist after attempting the above solutions, please contact Innovo customer support for further assistance.

6. Технические характеристики

7. Гарантия и поддержка

For warranty information, technical support, or any inquiries regarding your Innovo Deluxe iP900AP Fingertip Pulse Oximeter, please refer to the official Innovo webИли свяжитесь напрямую со службой поддержки клиентов. Контактная информация обычно указана на упаковке продукта или на официальном сайте производителя.

Innovo is a registered trademark of USPTO. The company actively pursues parties who infringe on their intellectual property rights. Innovo Pulse Oximeters are designed in the USA.