RollerHouses-logo

RollerHouses AC123-01D 16 Channel Wireless Controller

RollerHouses-AC123-01D-16-Channel-Wireless-Controller-profuvt

AC128 remote Instruction

RollerHouses-AC123-01D-16-Channel-Wireless-Controller (2)

Select the Chappel or Programming (for Multi-ShadÖremotes)

  1. Press “CHANNEL +” or “CHANNEL to select desired lights on. channel, it’s a single channel, not ALL(AL
  2. With paper clip or small screwdriver Pgess and Hold the Button. Shade motor rotate briefly up and
  3. Press the UP button on the Remote once. The shade rotates briefly up and Down(jogs) the pairing is finished
    RollerHouses-AC123-01D-16-Channel-Wireless-Controller (3)

Set the Upper/Lower position for the shade

  1. PRESS/HOLD the inset button on the BACK of the control. The shade rotates briefly up and down (jogs) to enter liming.
  2. Press the Por DOWN Buttons to adjust purdesired up position.
  3. Press the Settings button to save the limit button. The shade rotates briefly up and down(jogs,) the limit position is done.

Delete OF memory (including theveh10te and limits – resets the motor to factprébttings)

  1. PRESS the PROG BUTTON on the remote. Motor jogs once in Is, motor jogs t icoter, now all the limits have been deleted.RollerHouses-AC123-01D-16-Channel-Wireless-Controller (5)
  2. Change the DirectionRollerHouses-AC123-01D-16-Channel-Wireless-Controller (4)

Add a new controller a Shade

  1. Multiple controllers can be linked to one shade
  2. Press the STOP button of the paired remote. Motor jog once.  Up button of the new remote, otorjogs again, the new remote has been paired  the shades.
    RollerHouses-AC123-01D-16-Channel-Wireless-Controller (1)

Trouble shooting

Matter

  1. After installation, the motor does not turn
    1. Connect with wrong voltage
    2. Over loading
    3. Incorrect installation leads the motor sticking
    4. Change to correct with voltage
    5. Choose right motor torque
    6. Check the possible components
  2. The motor stops working
    Matter
    1. The  system prevents overheating after many repeated cycles
    2. The wall adapter is unplugged, orthe  batteries are drained. Solution
    3. After 10 minutes of non-use, the motor will work again
    4. Replug the wall adapter, or replace batteries

Documents / Resources

RollerHouses AC123-01D 16 Channel Wireless Controller [pdf] User Manual
AC123-01D, AC123-06D, AC123-16D, AC123-01D 16 Channel Wireless Controller, AC123-01D, 16 Channel Wireless Controller, Wireless Controller, Controller

References

Leave a comment

Your email address will not be published. Required fields are marked *