Rollerhouse DC2700 15 Channel Blind Controller Instructions

1. Technical parameters
   • Input: 5V
   • Frequency: 433.92 Mhz
   • Distance: 60 meters outside and 30 meters inside
   • Temperature: -20°-85°
   • Output Speed: 22-44 r/min (see name plate)
   • Running Limit: unlimited
   • Waterproof Grade: IP20
2. Match up
   
   • Press and hold Program button on motor head for 2 seconds, motor jogs and sends out long noise
   • Press P2 twice, the motor buzzes twice (The interval of twice pressing please not less than 0,5 second)
   • Press UP button motor jogs, and sends out noise for 6 times
3. Change direction
   
   
   • Press P2 twice, the motor buzzes twice (The interval of twice pressing please not less than 0.5 second)
   • Press DOWN button motor jogs, and sends out noise for 6 times
4. UP and DOWN limit setting
   
   
   • Press P2 button the motor jogs and sends out noise twice
   • Press UP button the motor jogs and sends out noise
   • Press P2 button the motor jogs and sends out noise
   • Press UP button, let the blinds reach. the desired limit position, then press STOP button and hold for 3 seconds
   • Press STOP button and hold for 3 seconds
   • Press DOWN button, let the blinds reach another desired limit position
5. Delete UP and DOWN limits
   
   
   • Press P2 button the motor jogs and sends out noise
   • Press DOWN button the motor jogs and sends out noise
   • Press P2 button the motor jogs and sends out noise
6. A third limit setting up
   
   
   • Press P2 button the motor jogs and sends out noise
   • Press STOP button twice the motor jogs and sends out noise for 4 times
   • If want to use the third limit. no matter where the blinds is press and hold STOP button for 3 seconds
7. Delete the third limit
   
   
   • Press and hold STOP button for 3 seconds, the blinds stop at the third limit position
   • Press P2 button the motor jogs and sends out noise.
   • position Press P2 button the motor jogs and sends out noise. Press
8. Tilt function / dot movement
   
   
   • Press P2 button the motor jogs and sends out noise
   • Press UP button the motor jogs and sends out noise
   • Press DOWN button the motor jogs and sends out noise
9. Add new transmitters
   
   
   • Press P2 button on a matched transmitter A twice, the motor jogs and sends out noise Di
   • Press P2 button on a new transmitter B, motor jogs, and sends out 7 times of Di

Documents / Resources

Rollerhouse DC2700 15 Channel Blind Controller [pdf] Instructions DC2700, DC2702, DC2700 15 Channel Blind Controller, 15 Channel Blind Controller, Blind Controller, Controller

References

• User Manual