ROLL-A-SHADE Contract Plus+ 7 Inch Dual Bottom Fascia
Product Information
Specifications
- Product Name: CONTRACT PLUS+ 7 DUAL BOTTOM FASCIA
- Manufacturer: Rollashade.com
- Contact: info@rollashade.com | 951.245.5077
- Hardware Included:
- Bracket Covers
- Motor Bracket
- Motor Bracket Idler End
- #14 Screw Screws
- Shades + Motors
- Fascia
- Zip Ties
- Wire Tie Pads
- Wall Switch
- Switch Box
- Tools Required:
- 3/8 Hex Head Phillips Head
- 1/8 Drill Bit
- Drill
Product Usage Instructions
- Inside or Outside Application
NOTE: ALL SHADES MAY BE PRE-PROGRAMMED TO SENSORS, REMOTES, AND/OR WALL SWITCHES UPON ARRIVAL - Mounting Location
Place your first bracket in its mounting location and mark the screw holes. Place your second bracket in its mounting location and repeat the process.
951.245.5077
HARDWARE INCLUDED
TOOLS REQUIRED
INSIDE OR OUTSIDE APPLICATION
**NOTE: ALL SHADES MAY BE PRE-PROGRAMMED TO SENSORS, REMOTES, AND/OR WALL SWITCHES UPON ARRIVAL**
MOUNTING LOCATION
Place your first bracket in its mounting location and mark the screw holes. Place your second bracket in its mounting location and repeat the process.
SCREW INSTALLATION
Next, pre-drill your screw holes using a 1/8” drill bit. Install the brackets with the provided screws using the 1/4” hex head driver.
ALIGNMENT
Check to make sure your brackets are level and aligned.
TOP SHADE PIN END INSTALLATION
Swivel ball bearing to align with idler shaft for easy installation. Press idler shaft all the way to the bracket.
TOP MOTOR END INSTALLATION
Remove locking ring. Lineup to motor bracket. Push motor into motor bracket.
TOP LOCK RING INSTALLATION
Add locking ring to motor bracket. Check motor is secured correctly.
BOTTOM SHADE PIN END INSTALLATION
Swivel ball bearing to align with idler shaft for easy installation. Press idler shaft all the way to the bracket.
BOTTOM MOTOR END INSTALLATION
Remove locking ring. Lineup to motor bracket. Push motor into motor bracket.
BOTTOM LOCK RING & FASCIA INSTALLATION
Add locking ring to motor bracket. Check motor is secured correctly. Install bottom fascia.
PLUG IN MOTOR
- Run motor power cord to nearest power outlet.
- Install wire tie pads and secure with zip ties to hold wire down.
- The path of the wire should be parallel with mullions and/or drop ceiling tiles ensuring the cable is neatly organized.
- Any modifications to the power cable should be done by a certified electrician to meet your city/state code requirements.
ADJUSTING LIMITS (IF NECESSARY)
See programming instructions based on the motor used for your application.
SHADE ADJUSTING (IF NECESSARY)
- Roll shade up and down to confirm hembar is level and material rolls up straight on center tube.
- If the hembar is not level, lower shade until you see the metal tube.
- Add layers of masking tape to the metal tube to the end that is too low until hembar is straight.
- If the material tracks to one side, lower shade until you see the metal tube.
- Add layers of masking tape to the metal tube to the end that is opposite the direction of tracking, until shade rolls up straight.
FAQ
Q: How do I adjust the limits of the shade?
A: See programming instructions based on the motor used for your application to adjust the limits of the shade.
Q: What tools are required for installation?
A: The tools required for installation are a 3/8 Hex Head Phillips Head, a 1/8 Drill Bit, and a Drill.
Documents / Resources
 | ROLL-A-SHADE Contract Plus+ 7 Inch Dual Bottom Fascia [pdf] Installation Guide Contract Plus 7 Inch Dual Bottom Fascia, Contract Plus, 7 Inch Dual Bottom Fascia, Dual Bottom Fascia, Fascia |
