QAZQA Kiko HL 5 Multicolor

QAZQA Kiko HL 5 MulticolorQAZQA Kiko HL 5 Multicolor 2WWW.QAZQA.COM

SAFETY INSTRUCTION

Please study the instruction manual and below information carefully before installing or using this product. Please keep this user manual for further reference

  1. The luminaires may only be installed by authorized and qualified technicians according to the valid regulations for electrical installation.
  2. Maintenance of the luminaires is limited to their surfaces. During maintenance, no moisture can come into contact with any areas of the terminal connections or voltage control parts.
  3. The electrical supply must be switched off at the outset, preferably by means of a switch in the distribution box, before any installation, maintenance, or repair work is undertaken.
  4. Exterior lighting must not be installed during rain.
  5. Take account of the minimum separation distance from other objects and the room required around the fitting.
  6. If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may be installed only by registered installers.
  7. Clamping screws in electrical connections must be adequately tightened. This is particularly the case with 12V low voltage conductors.
  8. When replacing a halogen lamp, wait for it to cool, for a minimum of 5 minutes.
  9. Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components
  10. Take account of all available technical information.
  11. Take note of the symbols when connecting wires:
    N =Neutral
    L =Live
    QAZQA Kiko HL 5 Multicolor - symbol=Earth
  12.  Meaning of symbols:

QAZQA Kiko HL 5 Multicolor- Meaning of symbolsFor indoor use only, where direct contact with water is impossible

This icon indicates the level of water-proof and dust-proof

Protection Class I: the fitting must be earthed

Protection Class II: the fitting is doubled insulated and does not require earthing

Protection Class III: the fitting is low voltage

Minimum distance from lighted objects (meters)

Only the self-shielded halogen lamp should be used with the luminaire

Strip the wire to the indicated length (mm)

Connect using the specified cable

The type of lamp and maximum size and wattage indicated in each lighting unit must not be exceeded
The armature is designed to work only with the indicated voltage. Different items require 50Hz different working voltage.
The luminaire can be used in combination with a dimmer Light Angle

The reference light angle and light space of the luminaire

This luminaire cannot be disposed of together with normal domestic waste in standard rubbish can, but you have to bring it to a staging area for electrical waste

Documents / Resources

QAZQA Kiko HL 5 Multicolor [pdf] Instruction Manual
Kiko HL 5 Multicolor, 103836

Leave a comment

Your email address will not be published.