How do I install and set up the ArduCom B0367 18MP Color Camera Module on my Raspberry Pi?

Accepted answer manuals.plus 2025-02-17 07:04:00

To install and set up the ArduCom B0367 18MP Color Camera Module on your Raspberry Pi, please follow the steps below:

1. Installation:
- Find the camera connector on the module and gently pull the plastic catch up.
- Insert the ribbon cable with the pins facing away from the catch.
- Push the catch back in.
- Connect the camera to the Raspberry Pi, ensuring that the pins are facing away from the catch.
- Connect the 2-pin power cable.
- Connect the 2-pin cable to Raspberry Pi's GPIO (5V & GND).

2. Before You Start:
- Make sure you are running a newer version of Raspberry Pi OS (04/04/2022 or later releases).
- A fresh install is highly recommended.

3. Install the camera driver:
- Open the terminal and run the following commands:
```
wget -O install_pivariety_pkgs.sh https://github.com/ArduCAM/Arducam-Pi...
chmod +x install_pivariety_pkgs.sh
./install_pivariety_pkgs.sh -p kernel_driver
```
- When prompted to reboot, press 'y' and then press enter to reboot.

4. Pull the repository:
- Run the following command in the terminal:
```
git clone https://github.com/ArduCAM/Arducam_to...
```

5. Change the directory to Arducam_tof_camera:
- Run the following command in the terminal:
```
cd Downloads/Arducam_tof_camera
```

6. Install dependencies:
- Run the following commands in the terminal:
```
chmod +x Install_dependencies.sh
./Install_dependencies.sh
```
- Raspberry Pi will automatically reboot.

7. Compile and run:
- Run the following commands in the terminal:
```
chmod +x compile.sh
./compile.sh
```
- Once it's successfully compiled, live previews of the camera will automatically pop up.

For more detailed information and troubleshooting, please refer to the user manual provided at https://www.arducam.com/docs/cameras-...

Instructions for Safe Use:
- Before connecting, always power off the Raspberry Pi and remove the power supply.
- Ensure that the cable on the camera board is locked in place.
- Make sure the cable is correctly inserted into the Raspberry Pi board's MIPI CSI-2 connector.
- Avoid high temperatures, water, moisture, or conductive surfaces while in operation.
- Avoid folding or straining the flex cable.
- Gently push/pull the connector to avoid damaging the printed circuit board.
- Avoid moving or handling the printed circuit board excessively while it's in operation. Handle it by the edges to avoid damage from electrostatic discharge.
- Store the camera board in a cool and dry place.
- Sudden temperature/humidity changes can cause dampness in the lens and affect image/video quality.

If you have any further questions or concerns, you can visit the Arducam website at www.arducam.com or contact their sales team at sales@arducam.com.