How do I hang the Teknik 5423411 Wall Mounted Peg Board horizontally?
I have purchased the Teknik 5423411 Wall Mounted Peg Board and I want to hang it horizontally on my wall. Can you provide instructions on how to do this?
To hang the Teknik 5423411 Wall Mounted Peg Board horizontally, follow these steps:
1. Assemble your unit on a carpeted floor or on the empty carton to avoid scratching your unit or the floor.
2. Turn the UNIT (A) onto its front edges.
3. Fasten the BRACKETS (3) to the short edges of the UNIT (A) using four SILVER 7/16" PAN HEAD SCREWS (6). Make sure to align the brackets exactly as shown in the instruction manual.
4. Measure the distance between the centers of the brackets. The centers should be spaced 25-5/8" apart.
5. Use a tape measure to measure the same distance on your wall and mark the locations with a pencil. The marks should be 2-1/4" down from the top of your unit.
6. Drill holes in the wall using a 1/4" drill bit at the marked locations.
7. Gently tap the WALL ANCHORS (4) into the holes in your wall using a hammer.
8. Turn two SILVER 1-1/2" PAN HEAD SCREWS (5) into the WALL ANCHORS (4) without completely tightening them. There should be approximately a 3/16" gap between the xxxx and wall anchor.
9. Carefully insert the screws in your wall into the large holes in the brackets on the back of your unit.
10. Set the unit down into place.
Please refer to the instruction manual for additional safety information and cleaning instructions.
Note: If you are attaching the Peg Board to a wall made of concrete, plaster, or other material, it is recommended to visit your local hardware store for proper hardware.
Answer this question
Answers are reviewed before publication.