How do I reset the Ready Hot Water Dispenser after a power outage?
After a power outage, my Ready Hot Water Dispenser stopped working. I'm not sure how to reset it and get it working again. Can you provide instructions on how to reset the dispenser?
To reset the Ready Hot Water Dispenser after a power outage, follow these steps:
1. Make sure the power is restored and the dispenser is plugged into a properly grounded electrical outlet.
2. Locate the thermostat control dial on the front of the dispenser. It should be in the OFF position (fully counterclockwise).
3. Turn the thermostat control dial to the ON position (fully clockwise).
4. Fill the tank with water by turning on the faucet and allowing water to flow into the tank for about 1 minute.
5. Wait for approximately 15 minutes for the water to heat up to the desired temperature.
6. Test the dispenser by turning on the faucet and checking if hot water is flowing properly.
If the dispenser still does not work after following these steps, refer to the troubleshooting section in the user guide or contact the manufacturer's customer support for further assistance
Answer this question
Answers are reviewed before publication.