How do I connect the Avenview HDMI Quad Multiviewer to my devices?
To connect the Avenview HDMI Quad Multiviewer, follow these steps:
1. Connect your HDMI sources (such as computers, DVD players, or gaming consoles) to the HDMI inputs on the Matrix Switch (SW-HDM3D-C6-4x4E).
2. Connect each HDMI CAT5/6 output on the SW-HDM3D-C6-4x4E to the respective CAT5/6 input on the remote receiver HDM3D-C6SW-R.
3. Connect the IR BLASTER cable to the SW-HDM3D-C6-4x4E and direct the IR emitter to the built-in IR receiver of the sources.
4. Connect the +5V 6A DC power supply to the SW-HDM3D-C6-4x4E.
5. Power on all HDMI sources.
6. Power on the SW-HDM3D-C6-4x4E.
7. Connect each HDMI output of the remote receiver to HDMI displays.
8. Connect the CAT5E/6 INPUT on the HDM3D-C5SW-R to the CAT5E/6 OUTPUT port on the SW-HDM3D-C6-4x4E.
9. Connect the IR receiver and place it in a position where it can receive the IR command signals from the users.
10. Dial the 8-level rotary control switch on the HDM3D-C6SW-R to adjust the HDMI signal level until the picture and sound are clear.
Please refer to the user manual for more detailed instructions and illustrations.
Answer this question
Answers are reviewed before publication.