How do I charge the LED light in the Dan&Darci Unicorn Light-Up Terrarium Kit?
I received the kit and I'm not sure how to charge the LED light. Can you provide instructions on how to do it?
To charge the LED light in the Dan&Darci Unicorn Light-Up Terrarium Kit, follow these steps:
1. Connect the Micro-USB charging cable to the charging port located on the bottom of the light-up jar lid.
2. Plug the other end of the cable into a USB power source, such as a computer, wall adapter, or power bank.
3. Leave the LED light to charge for a few hours until it is fully charged. The charging indicator on the lid will turn off when the battery is fully charged.
4. Once the LED light is fully charged, disconnect the Micro-USB cable from the charging port.
Note: It is recommended to fully charge the LED light before using it for the first time. If the LED light does not turn on or appears dim, it may need to be recharged. Make sure to recharge the LED light after each use to ensure optimal performance.
For more detailed instructions, please refer to the "Setup Guide" section in the Dan&Darci Unicorn Light-Up Terrarium Kit user manual.
Answer this question
Answers are reviewed before publication.