How do I calibrate the Preciva DG00135 Digital Angle Finder?
I recently purchased the Preciva DG00135 Digital Angle Finder and I'm not sure how to calibrate it. The manual mentions calibration, but it doesn't provide specific instructions on how to do it. Can you please explain the calibration process for this angle finder?
Calibrating the Preciva DG00135 Digital Angle Finder is a simple process. Here are the steps to calibrate the angle finder:
1. Place the angle finder on a flat, level surface. It is important to ensure that the surface is completely flat to get accurate calibration.
2. Press and hold the "zero" button on the angle finder for a few seconds until the display shows "CAL" or "CALIBRATION" mode.
3. While in calibration mode, make sure that the angle finder is not moved or disturbed.
4. After a few seconds, the angle finder will automatically calibrate itself and display "CAL OK" or a similar message indicating that the calibration is complete.
5. Once the calibration is done, you can start using the angle finder for accurate measurements.
It is worth noting that the Preciva DG00135 Digital Angle Finder may not require frequent calibration, especially if it is handled carefully and stored properly. However, if you notice any inaccuracies in the readings or suspect that the angle finder is not calibrated correctly, you can repeat the calibration process to ensure accurate measurements.
For more detailed instructions and illustrations, please refer to the user manual provided with the Preciva DG00135 Digital Angle Finder.
Answer this question
Answers are reviewed before publication.