How do I use the Schumacher SC1355 Automatic Battery Charger?
I recently purchased the Schumacher SC1355 Automatic Battery Charger and I'm not sure how to use it properly. Can you provide step-by-step instructions on how to use this charger?
Sure! Here are step-by-step instructions on how to use the Schumacher SC1355 Automatic Battery Charger:
1. Preparing to Charge:
- If necessary, remove the battery from the vehicle. Always remove the grounded terminal from the battery first and make sure all accessories in the vehicle are turned off.
- Ensure the area around the battery is well-ventilated.
- Clean the battery terminals and add distilled water if needed, following the battery manufacturer's instructions.
- Determine the voltage of the battery and set the output voltage selector switch on the charger accordingly.
- If the charger has an adjustable charge rate, start with the lowest rate.
2. Charger Location:
- Place the charger as far away from the battery as the DC cables allow.
- Do not place the charger directly above the battery to avoid corrosion and damage.
3. DC Connection Precautions:
- Before connecting or disconnecting the DC output clips, make sure any charger switches are in the "off" position and the AC cord is unplugged.
- Attach the clips to the battery and chassis as indicated in sections 6 and 7 of the manual.
- Never allow the clips to touch each other.
4. Charging a Battery in the Vehicle:
- Turn off all vehicle accessories and keep the hood open.
- Connect the battery clamps or ring connectors to the battery following the precautions in sections 6 and 7.
- Plug the charger into an electrical outlet.
- When charging is complete, disconnect the charger from the AC power, remove the clamps from the vehicle's chassis, and then remove the clamp from the battery terminal.
5. Charging a Battery Outside of the Vehicle:
- Place the battery in a well-ventilated area.
- Connect the battery clamps or ring connectors to the battery following the precautions in sections 6 and 7.
- Plug the charger into an electrical outlet.
- When charging is complete, disconnect the charger from the AC power, disconnect the negative clamp, and then the positive clamp.
6. Using the Quick-Connect Cable Connectors:
- Connect the charger's output cable leads to the quick-connect battery clamp cable.
- Follow the steps in sections 6 and 7 to connect the output clamps to the battery.
- Plug the charger into an electrical outlet.
7. Using the 50 Amp Battery Clamps:
- Connect the charger's output cable to the quick-connect battery clamp cable.
- Follow the steps in sections 6 and 7 to connect the output clamps to the battery.
- Plug the charger into an electrical outlet.
8. Using the Ring Connectors:
- Loosen and remove the nuts from the battery terminal bolts.
- Connect the red positive connector ring to the positive battery terminal and the black negative connector ring to the negative battery terminal.
- Replace and tighten the nuts to secure.
- Connect the cable to the end of the charger's output cord.
- Plug the charger into an electrical outlet.
Remember to refer to the manual for specific details and precautions related to your battery type and charging needs.
Answer this question
Answers are reviewed before publication.