How do I connect my phone to the JBL TUNE 225TWS earbuds via Bluetooth?

To connect your phone to the JBL TUNE 225TWS earbuds via Bluetooth, please follow these steps:

1. Make sure the earbuds are charged and turned on.
2. Open the Bluetooth settings on your phone.
3. On the earbuds, press and hold the button on the right earbud for about 3 seconds until the LED indicator starts flashing blue.
4. In your phone's Bluetooth settings, look for "JBL TUNE 225TWS" and select it to pair.
5. Once connected, the LED indicator on the earbuds will turn solid blue.

If the earbuds are not showing up in your phone's Bluetooth settings, try the following troubleshooting steps:

1. Ensure that the earbuds are in pairing mode by pressing and holding the button on the right earbud until the LED indicator starts flashing blue.
2. Restart your phone and try again.
3. Reset the earbuds by placing them back into the charging case and then removing them. Press and hold the button on the right earbud for about 10 seconds until the LED indicator flashes white.
4. If you have previously paired the earbuds with another device, make sure that device is not in range or has Bluetooth turned off.
5. Consult the JBL TUNE 225TWS manual for further troubleshooting steps or contact JBL customer support for assistance.

Please note that the specific steps may vary depending on your phone's operating system. For detailed instructions, refer to the JBL TUNE 225TWS manual available on the JBL website.