How do I program the Panic Button for specific functions?
To program the for specific functions, follow these steps:
1. Access the MMI Menu:
- The MMI menu is accessible when the device is initially scanning for a network or within 60 seconds after joining a network.
- To re-enable the MMI menu, you can either press and hold the button for 10 seconds until the LED flashes green or remove and re-insert the battery after a 10-second wait.
2. Push Button Menu:
- When the MMI menu is active, push the button to cycle through different menu modes.
- Push and hold the button for a few seconds to set the device into a desired mode. The mode changes at 5-second intervals.
3. Programming Functions:
- For specific functions like a safety button, door lock button, or alarm button for the elderly:
- Use the Push Button Menu to navigate to the desired mode.
- Follow the prompts on the LED indicator to set up the function you want.
- The Panic Button can be programmed to function as a safety button for emergencies, a door lock button, or an alarm button for the elderly or disabled.
4. Ensure Proper Functionality:
- Make sure the Panic Button is within range of the Zigbee network for proper functionality.
- Test the programmed functions to ensure they work as intended.
By following these steps, you can program the Develco Products PBTZB-110 Panic Button for specific functions according to your requirements.
Original question and details
I have the Develco Products PBTZB-110 Programmable Panic Button, and I want to program it for specific functions like a safety button, door lock button, or alarm button for the elderly. How can I set up these functionalities?
Answer this question
Answers are reviewed before publication.