User Manual Q&AAnswer
Dec 17, 2025 - 12:19 PM
According to the CLiCK GRID PRO 20A Modules user manual, to wire a 2-way switch on a 1-way circuit, you should use only the Common and L1 terminals on the switch. This means you will connect the incoming and outgoing live wires to the Common terminal and the L1 terminal. By doing this, you can effectively use a 2-way switch to control a single circuit, allowing you to operate the circuit from two different locations. Make sure to follow the provided wiring instructions carefully and consult a qualified electrician if you are unsure about the installation process.
Add New Comment