User Manual Q&AAnswer
Dec 16, 2025 - 08:38 AM
To connect and set up the EX-1280 Digital Signal Processor, follow these steps as outlined in the installation guide:
1. **Download and Install ControlSpace Designer Software:** Download the ControlSpace Designer software to your computer to configure the processor.
2. **Rack-Mounting:** Mount the processor in a standard 19-inch rack using appropriate mounting hardware.
3. **Analog Audio Connections:** Make balanced audio connections using Euroblock connectors for both inputs and outputs.
4. **AmpLink Connection:** If using an AmpLink-enabled amplifier, connect the AmpLink port on the processor to the amplifier using a shielded Cat 5 cable.
5. **Dante Network Connection:** Connect the Dante network ports on the processor to your Dante digital audio devices using Ethernet cables.
6. **Far-End Connections:** Connect VoIP, telephone, USB, and other external devices as needed.
7. **Remote Control and GPIO Connections:** Interface the processor with external control hardware using GPIO connections.
8. **Power Connection:** Connect the processor to a power outlet using the included power cord.
9. **Configuration with ControlSpace Designer:** Use the ControlSpace Designer software to configure the processor for your specific audio system requirements.
By following these steps and referring to the detailed instructions in the installation guide, you can successfully connect and set up the EX-1280 Digital Signal Processor for operation in your audio system.
Add New Comment