User Manual Q&AAnswer
Dec 15, 2025 - 11:23 PM
To access and configure the D-Link DGS-1510-28X Smart Managed Gigabit Switch using a web browser, follow these steps as outlined in the user manual:
1. **Connect Equipment:**
- Connect a PC with an RJ-45 Ethernet connection to any of the ports on the front panel of the switch using a standard Ethernet cable.
2. **Set IP Address:**
- Ensure that the PC has an IP address in the same range as the switch. For example, if the switch has an IP address of 10.90.90.90, set the PC's IP address to 10.x.y.z (where x/y is a number between 0 ~ 254 and z is a number between 1 ~ 254) with a subnet mask of 255.0.0.0.
3. **Access Web Interface:**
- Open a web browser (e.g., Internet Explorer, Firefox, Chrome, Safari) on the PC.
- Enter http://10.90.90.90 (factory-default IP address) in the address bar and press Enter.
- Alternatively, access the web configuration through the D-Link Network Assistant (DNA) by clicking the IP hyperlink in the device list.
4. **Login:**
- When prompted, enter "admin" for both the Username and Password.
- Choose the language for the Web-based Management interface and click Login.
5. **Configuration:**
- Follow the Smart Wizard to configure functions like IP Information, User Account, and SNMP Settings. If no changes are needed, exit the Wizard and proceed to the Web-based Management interface.
By following these steps, you can access and configure your D-Link DGS-1510-28X Smart Managed Gigabit Switch using a web browser for easy management and monitoring. For more detailed instructions, refer to the user manual provided with the switch.
Add New Comment