User Manual Q&AAnswer
Dec 13, 2025 - 04:06 AM
To configure the Marport TE-TS V2 Trawl Speed Sensor using the Mosa2 configuring tool, follow these steps:
1. **Wireless Connection Setup:**
- Activate the sensor outside sea water by using a jumper to connect and disconnect the negative charge and the water switch.
2. **Using Mosa2 Configuring Tool:**
- Connect the sensor to the Mosa2 configuring tool either wirelessly or with the Configuration Cable on a Mac OS device.
- Configure all settings for your sensor using the Mosa2 tool.
- Export the sensor settings for future reference.
3. **Important Notes:**
- Only advanced users or Marport technicians should configure the sensor.
- Ensure that your sensor configuration (Mosa2) matches the receiver configuration (Scala2), especially the uplink frequency of the sensor.
- Maintain a sufficient distance between the sensor frequency and other sensor frequencies.
For further detailed information on configuring the Marport TE-TS V2 Trawl Speed Sensor using the Mosa2 configuring tool, refer to the speed sensor user guide provided by Marport.
Add New Comment