User Manual Q&AAnswer
Dec 12, 2025 - 09:57 PM
Cleaning the Flow Unit after each use is essential to maintain its performance and accuracy. Here is a step-by-step guide on how to clean the Flow Unit properly:
1. **Rinse with Water:** Start by rinsing the entire system with water to remove any residual fluids.
2. **Use Non-Foaming Detergent:** Clean the Flow Unit with a non-foaming detergent that is compatible with the Flow Unit, the rest of your setup, and the fluids used during your experiment.
3. **Disinfectant Rinse:** Remove all contaminants using a disinfectant like Javel bleach. Rinse the Javel bleach or disinfectant with water.
4. **Final Rinse with Isopropanol:** Rinse the entire system with isopropanol to ensure there are no traces left on the Flow Unit.
5. **Install Sensor Yellow Plugs:** After cleaning, make sure to install the yellow plugs provided with the Flow Unit for storage.
By following these cleaning steps, you can prevent debris buildup and ensure the longevity and accuracy of your Flow Unit. Remember to clean the Flow Unit after each use and before storing it for an extended period.
Add New Comment