User Manual Q&AAnswer
Dec 12, 2025 - 04:30 PM
To properly install the Code 3 2021 Dodge Durango Citadel emergency warning device, follow these steps as outlined in the instruction manual:
1. **Step 1:** Remove the screws from all light heads and pull them away from the housing.
2. **Step 2:** Locate the bracket onto the spoiler using the 3rd brake light as a guide.
3. **Step 3:** Mark and drill three (3) xxxx holes with an 1/8” drill bit.
4. **Step 4:** Mount the product using the supplied hardware and torque to 20in-lbs.
5. **Step 5:** Reinstall the lights using the removed screws and torque to 10in-lbs.
6. **Step 6:** Repeat steps 1-5 for the other side.
7. **Step 7:** Raise the lift gate and remove the grommet near the door hinge on the left side of the vehicle.
8. **Step 8:** Carefully pull back the lift gate water seal rubber extrusion to expose the edge of the headliner.
9. **Step 9:** Drill a 1in diameter hole near the door hinge on the right side of the vehicle.
10. **Step 10:** Route each harness around the edge of the spoiler and feed the harness end through the holes.
11. **Step 11:** Apply adhesive supplied with the kit to the outer edges of the harness grommets and fully seat the harness grommets in their respective holes.
12. **Step 12:** Clean the surface below the lift gate and secure the harnesses using the supplied wire ties and wire tie holders.
13. **Step 13:** Refer to the product-specific manual to form the proper connections.
Following these installation steps will help ensure that the Code 3 2021 Dodge Durango Citadel emergency warning device is installed correctly and functions as intended. Remember to always refer to the instruction manual for detailed guidance and safety precautions.
Add New Comment