User Manual Q&AAnswer
Dec 12, 2025 - 03:30 PM
According to the user manual for the Drywise Pre-Heater add-on, you can confirm if the add-on is installed correctly by checking the following:
1. **Thumbscrew and Dowel Pin:** Make sure the thumbscrew and dowel pin are securely fastened after placing the Pre-Heater add-on in position. The thumbscrew should be tightened to secure the add-on in place.
2. **Input Port Cover:** Ensure that the input port cover has been removed before installing the Pre-Heater add-on.
3. **Filament Input Port:** Locate the filament input port on the Drywise Inline Filament Dryer and confirm that the Pre-Heater add-on is properly aligned and connected to this port.
4. **Warning Message:** If the Drywise system detects that the Pre-Heater add-on is not installed correctly or is malfunctioning, a warning message screen will be displayed indicating the issue. If you see a "Pre-Heater not detected" message, it means there is an installation problem that needs to be addressed.
By following these steps and ensuring that the thumbscrew is securely tightened, the Pre-Heater add-on should be correctly installed and ready for use with your Drywise Inline Filament Dryer.
Add New Comment