User Manual Q&AAnswer
Dec 09, 2025 - 09:21 PM
If your UREVO SP1 LITE Walking Treadmill is not working as expected, here are some troubleshooting steps you can follow based on the user manual:
1. **No Working:**
- Check if the power rock switch is functioning. If it doesn't light on, replace it with a new one.
- Ensure that the power supply is not interrupted.
- If the power cord is damaged, replace it with a new one.
2. **Walking Belt Slips:**
- If the walking belt is slipping, it may be due to it being loose. Tighten the walking belt tension with the hex tool provided.
3. **Remote Control Issue:**
- If the remote control is not working, it could be due to incorrect use of default settings, low battery power, or a malfunctioning remote control. Try replacing the battery cells or the remote control itself.
4. **Friction Noise:**
- If there is friction noise, it could be because the walking belt is off-center. Follow the manual centering process to adjust the belt alignment.
5. **Error Codes:**
- If you encounter error codes like E02, E06, E07, or E08, refer to the manual for specific fault analysis and resolutions. Contact after-sale service if needed.
6. **General Maintenance:**
- Regularly clean the treadmill after each use with a damp cloth.
- Lubricate the walking belt every 3 months with the lubricant oil provided.
- Ensure the treadmill is on a level surface and away from moisture.
If the issue persists after following these troubleshooting steps, it is recommended to contact UREVO's customer service department for further assistance. Remember to provide them with detailed information about the problem and any error codes displayed for a more accurate diagnosis and resolution.
Add New Comment