User Manual Q&AAnswer
Dec 09, 2025 - 01:04 PM
To connect multiple beamZ Pollux 2500 Analog Laser Systems together for operation, follow these steps as per the user manual:
1. **DMX Connection:** If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
2. **Terminating Resistor:** At the last unit in the DMX chain, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
3. **Power Connection:** The unit has a power connector output on board. Depending on the local conditions, several units can be linked by power connection in- and output. Connect a maximum of four units in a row when using 230V/16A. Use an approved three-core cable with a cross-section of at least 1.5 mm².
By following these steps, you can connect and operate multiple beamZ Pollux 2500 Analog Laser Systems together seamlessly.
Add New Comment